tender for drinking water scheme - payjal yojana work under edd-i baraut, work of issuing electricity connection for (tank) under drinking water scheme in village baoli, mahavatpur baoli, barwala, soup and jonmana against the approved packages under the scheme deposited in the jurisdiction of electricity distribution division-i, baraut., delivery of the following materials from the power storage center baghpat/baraut to the 33/11 kv substation/work site which includes loading and unloading. st pole (11m), pcc pole (8.5m) 25 kva transformer 63 kva transformer work of hauling line material like 11 kv pin, 11 kv pin insulator, 11 kv disc stay wire, acsr, weasel conductor etc. work of transportation of three phase sb cable (3.5×150mmsq) from power storage center baghpat. work of hauling three phase sb cable (4x25mmsq) from power storage center baghpat. work of carrying cable (3x70mmsq xlpe) from power storage center baghpat. work of strengthening 8.5/11 meter pcc pole by digging deep pit. to make double pole, digging pit and inserting st pole and filling the pit again. (3x70mmsq xlpe) jointing cable box (jointing cable box kit payable by the department) all line material work on double pole holding clamp with nut and bolt installation work including 11 kv pin insulator pin installation work including fitting of 11 kv disc insulator installation work including 11 kv cross arm fitting, work of installation of ss channel 125×65×1300 mmt installation work of ss channel 125×65×2240 mm top off work of installation of ss channel 100×50×2028 mm dropper off. s.s. angle 75x75x6x2028 mm (converter base) off installation work polo grouting work. installation of stays (including grouting). work of installing 25/63 kva transformer on double pole. the work of earthing the neutral and body of the transformer. line construction work by acsr weasel conductor. stone pad laying work work of making lt single phase (1×25+1×16) sqmm abc line. work of making line of lt abc (3x50+1x35+1x16 sqmm). installation work of lt (4×25mmsq) three phase cable. connecting the consumer by jumpering from the ht side and connecting the cable from the lt site. laying of overhead xlpe 11 kv cable as per site requirement (by placing clamps/packing at appropriate distance through earthing/staywire between tow poles) as per site requirement (done by decentralized material supplier) 11 kv fuse set installation work, (materials payable by contractor) including nuts and bolts f clamp nut with bolt holding clamp with nut bolt note 1. all work will have to be done as per respo standards. 2. the quantity of the above work number 01 to 36 is completely estimated and according to the requirement of the work, the quantity of any work can be from zero to maximum (within the limit of the tender amount). 3. as per the orders of the assistant officer, work can be done in any section/sub-division under the electricity distribution board, baghpat. 4. in case item wise prevailing/market rate is not obtained in the above work, item wise negotiation will be done.