tender for drinking water scheme work under edd-i baraut, in village tanda, badarkha, hewa, shahpur badauli and ramala against the packages approved under the deposit scheme in the area of ​​electricity distribution division-i, baraut. work of issuing electricity connection for (tank) under drinking water scheme, delivery of the following material from the power storage center baghpat/baraut/meerut to the 33/11 kv substation/work site, which includes loading and unloading. st pole (11m) pcc pole (8.5m) 25 kva transformer 63 kva transformer work of hauling line material like 11 kv pin, 11 kv pin insulator, 11 kv disc stay wire, acsr, weasel conductor etc. work of transportation of three phase sb cable (3x50+1×35+1×16mmsq) from power storage center baghpat. work of hauling three phase sb cable (4x25mmsq) from power storage center baghpat. work of erecting 8.5/11 meter pcc pole by digging deep pit. to make double pole, erecting st pole by digging pit and filling the pit again. all line material work on double pole holding clamp with nut and bolt installation work including 11 kv pin insulator pin installation work including fitting of 11 kv disc insulator work of installation of ss channel 125×65×1300 mmt installation work of ss channel 125×65×2240 mm top off, installation work of ss channel 100x50x2028 mm dropper off. s.s. angle 75x75x6x2028 mm (converter base) off installation work polo grouting work. installation of stays (including grouting). work of installing 25/63 kva transformer on double pole. the work of earthing the neutral and body of the transformer. line construction work by a.c.s.r. weasel conductor. stone pad laying work work of making line of lt abc (3x50+1x35+1×16 sqmm). installation work of lt (4×25mmsq) three phase cable. connecting the consumer by making a jumper from the ht side and connecting the cable from the lt site. 11 kv fuse set installation work suspension clamp installation dead clamp installation installation of distribution box (materials payable by contractor) including nuts and bolts holding clamp with nut bolt, note 1. all work will have to be done as per respo standards. 2. the quantity of the above work number 01 to 33 is completely estimated and according to the requirement of the work, the quantity of any work can be from zero to maximum (within the limit of the tender amount). 3. as per the orders of the competent officer, work can be done in any section/sub-division under the electricity distribution board, baghpat. 4. in case item wise prevailing/market rate is not obtained in the above work, item wise negotiation will be done.