replacement of components to 175 kva servo voltage stabilizer installed at t / well greater kailash along with allied works under non plan- 1 replacement of components to 175 kva servo voltage stabilizer installed at t/well greater kailash by way of disconnecting all the electrical connection and draining of t-oil and storing it properly in barrels and then dragging out the stabilizer from pump room with the help of crane/ manual labour and with the help of heavy tools and tackles at site and then shifting of avr servo and t-oil barrels to workshop by deploying load carrier, crane and skilled labour. dismantling of avr servo, extracting its dimmer assemblies and coils. providing/ replacement of01 no. main coil, 02 nos. dimmer coils and servicing and cleaning of remainingcoils with replacement of carbon brushes and carbon brush holders. providing and fitting of 02 nos. auto sensing cards., and then shifting of avr servo from workshop to t/well greater kailash and providing & filling of fresh 150 litres t-oil in tank .the job includes making all electrical connections by shifting back the power cables to the repaired avr servo after proper thimbling and crimping of the power cables with new thimbles of suitable size and specifications and testing it on no load and then on of full load on site. complete job includes the cost of material, labour and handling charges 2 upkeepment of 6000 gph x 80 mtrx 12.5 hp submersible pumpset of t/well sec-14 nanak nagar by way of disconnection of power supply and extraction of submersible pumpset using skilled labour with allied tools and tackles. dismantling and shifting of pumpset to workshop by mech. transport. repairing by providing, fabrication and fitting of s.s pump shaft as per sample, 8no. impellers, 6 no. pump bodies, 8no. neck rings, 8no. body bushes, ss coupling pulley and nut bolts and assembling of punp atworkshop. the job includes dismantling and repairing of 12.5 hp submersible motor by providing, fabrication and fitting of thrust pad set and rotor bushes. assembling of the motor, coupling with pump and testing the pumpset in the test pit then shifting of pumpset to the site of installation. making electrical connections of motor with sub cable by making leak proof joint and lowering of pump set along with providing and replacing rubber gaskets and nut bolts. making connections of submersible cable with panel and then testing on full load