tender for providing and laying of hot applied thermoplastic compound 2.5mm thick including reflectoring glass beds @ 250 grms per sqm. area thickness of 2.50mm is exclusive of surface applied glass beds as per irc:35. the finished surface to be level, uniform and free from streaks and holes etc., complete (as per morth specification no. 803) , providing and fixing reflective road studs of ‘category a raised pavement markers made out of poly carbonate/methyl methecrylate/abs moulded body conforming to astm d 788 and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face with retro reflectance and chromaticity values conforming to astm d4280. the reflective raised pavement markers shall also confirm to the mort&h circular no rw / nh. 33023/10/ 97-do.iii dt 11.06.97 the height, width and length shall not be less than 15 mm, 90mm and 100 mm and with minimum reflective area of 13 sq.cm. on each side and the slope to the base shall be 35+/-5 degree. each reflector shall have a cil not less than values specified in table 2 of said mort&h circular.the strength of detachment of the integrated cylinderical shanks,(of diameter not less than 19 +/- 2mm and height not less than 30 +/- 2mm ) from the body is to be a minimum value of 500kgf.fixing will be by drilling holes on the road for the shanks to go inside,without nails and using epoxy resin based adhesive as per manufacturers recommendation and complete as directed by the engineer.the marker shall support a load of 13635kg tested in accordance with astm d4280 and confirming to irc 35 -2015 guide lines and mort&h specification 804 etc., complete. , providing and erecting of retro-reflectorised cautionary, mandatory and informatory signs (without definition board) made out of high intensity prismatic grade sheeting confirming type iv standards of irc: 67-2012 and astmd 4956-09,specification and fixed over 2.00mm thick aluminium sheet fixed over a back su