tender for road marking with hot applied thermoplastic compound with reflectorising glass beads on bituminous surface. providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per irc:35- 2015. the finished surface to be level, uniform and free from streaks and holes etc., complete as per mort&h specification no.803 , road markers/road stud with lens reflector providing and fixing reflective road studs of ‘category a raised pavement markers made out of poly carbonate / methyl methercrylate/abs moulded body confirming to astm d 788 and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face with retro reflectance and chromaticity values conforming to astm d4280. the reflective raised pavement markers shall also confirm to the mort&h circular no rw / nh. 33023/10/ 97-do. iii dt 11.06.97. the height, width and length shall not be less than 15 mm, 90 mm and 100 mm and with minimum reflective area of 13 sq.cm on each side and the slope to the base shall be 35 (+/-) 5 degree. each reflector shall have a cil not less than values specified in table 2 of said mort&h circular. the strength of detachment of the integrated cylindrical shanks, (of diameter not less than 19 (+/-) 2mm andheight not less than 30 (+/-) 2 mm) from the body is to be a minimum value of 500 kgf. fixing will be by drilling holes on the road for the shanks to go inside, without nails and using epoxy resin based adhesive as per manufacturers recommendation and complete as directed by the engineer. the marker shall support a load of 13635 kg tested in accordance with astm d4280 and confirming to irc 35 - 2015 guidelines and mort&h specification 804 etc., complete , calculation of subtotal, gst and total amount carried out by system automatically , basic cost of value put to tender as per estimate