tender for deoband rankhandi ghaloli road par thermoplastic paint se road marking work - providing and laying of yellow colour hot applied thermoplastic compound 5 mm thick including reflectorising glass beads @500 gms per sqm area, thickness of 5 mm is exclusive of surface applied glass beads as per irc:35 .the finished surface to be level, uniform and free from streaks and holes complete excluding gst.(lko sor ch. 26 si. no. 3 new item)(repeated/transverse bar marking). 2 providing& laying of hot applied thermoplastic compound 2-5 mm thic including reflectorising glass beads@ 250 gms per sqm, area, thickness of 2.5 mm exclusive of surface applied glass beads as per irc 35 the finished surface to be level, uniform and free from steaks and holes complete excluding gst. (sor. ch. 27 si. no. 7 new item) 3 reflective raised pavement marker with shanks providing and fixing of raised pavement markers with twin shanks of adequate length anchored with epoxy / bitumen adhesive of approved make(cat eye) type x-astmd-4956-04 avery dennision/3m(usa make) having moulded body of polycarbonate, asa, hips or abs able to support a load of 13.635 m.t. tested in accordance with astmd 4280 type h and other requirement mentioned in mort&h circular, its reflective lens made of micro prismatic lens (capable of providing total internal reflection of light), electronically welded to the body. the length, height and width of the body shall not exceed 130 mm, 20 mm and 105 mm respectively, the area of each reflective surface shall not be less than 13 sq. cm . on each side sloping at the angle of 35 + 5 degree to the base to ensure maximum reflectively. it shall comply to specification of category a of mort&h circular no. rw/nh 33023/10/97-do-iii dated 11.06.97 lenses shall be moulded of methyl methecrylate conforming to astmd 788 or equivalent. with 7 years warranty. rate shall be inclusive of all taxes, royalty,etc. etc. all t&p/ machine material and labour required for proper completion of work.