annual plan-kadakkavoor gp prjt no. 101/25-26-further construction of gender resource center-general civil work -- 1 gender resource 2 50.6.1.4:solid block masonry using pre cast solid blocks (factory made) of size 30x20x20cm or nearest available size confirming to is 2185 part i of 1979 for foundation and plinth with thickness 20cm and above in: cm 1:6 ( 1 cement : 6 coarse sand ) etc complete 3 50.6.3.2:solid block masonry using pre cast solid blocks (factory made) of size 40x20x10 cm or nearest available size confirming to is 2185 part i of 1979 for super structure up to floor two level for 10 cm thick wall in : cm 1:6 ( 1 cement : 6 coarse sand) including cost of scaffolding complete 4 13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) 5 50.12.4.2:providing and fixing false ceiling with 7.5 mm thick pvc wooden grains panel board ceiling of approved quality in aluminium frame work with necessary screws etc complete ( aluminium frame work shall be paid separately) 6 11.37:providing and laying ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to is : 15622 of approved make in colours such as white, ivory, grey, fume red brown, laid on 20 mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc., complete 7 21.1.1.1:providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/ appropriate z sections and other sections of approved make conforming to is : 733 and is: 1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required epdm rubber/ neoprene gasket etc. aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, aluminnium snap beading for glazing /paneling, c.p. brass/ stainless steel screws, all complete as per architectural drawings and the directions of engineer-in-charge.(glazing, paneling and dash fasteners to be paid for separately):for fixed portionanodised aluminium (anodised transparent or dyed to required shade according to is : 1868, minimum anodic coating of grade ac 15) 8 21.2.1:providing and fixing 12 mm thick prelaminated particle board flat pressed three layer or graded wood particle board conforming to is : 12823 grade i type ii, in panelling fixed in aluminum doors, windows shutters and partition frames with c.p. brass / stainless steel screws etc. complete as per architectural drawings and directions of engineer - in- charge.pre-laminated particle board with decorative lamination on one side and balancing lamination on other side 9 21.3.1:providing and fixing glazing in aluminium door, window, ventilator shutters and partitions etc. with epdm rubber / neoprene gasket etc. complete as per the architectural drawings and the directions of engineer - in -charge. ( cost of aluminium snap beading shall be paid in basic item):with float glass panes of 4.0 mm thickness (weight not less than 10kg/sqm)