road marking with hot applied thermoplastic compound under cooch behar division, pwd during the year 2025-26.= 1 road marking with hot applied thermoplastic compound with reflectorising glass beads on bituminous surfaceproviding and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per irc:35. the finished surface to be level, uniform and free from streaks and holes complete as per clause 803 of specifications for road & bridge works of mort&h (5th revision). 2 supplying & fixing of raised pavement markers/ road studs/ cats eye made of polycarbonate moulded body and reflcetive panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face which shall support a load of 13635 kg tested in accordance to astm d 4280 type h and complying to clause no. 804 of mort&hs specification for road & bridge works (fifth rev.). marker height shall not be less than 10 mm and shall not exceed 20 mm, width shall not exceed 130 mm and with minimum reflective area of 13 sq.cm. on each side and slope to the base shall be 35±5 degree. fixing will be without nails but by using epoxy resin based adhesive as per manufacturers recommendation including site cleance etc. and complete as directed by the engineer in charge. the contractor will have to provide a test certificate from a reputed national/ international laboratory conforming the above specifications. 3 clearing grass and removal of rubbish clearing grass and removal of rubbish up to a distance of 30 m outside the periphery of the area as per technical specifications clause 201 for rural roads of mord.by manual means 4 add gst @ 18.00% on sum ofamount sl-01 to sl-28 5 add cess @ 1.00% on sum ofamount sl-01 to sl 29