tender for construction of t junctions and road safety work at kilometers 1 6 10 13 15 and 22 on janta road in district saharanpur - road marking with hot applied thermoplastic compound with reflectorising glass beads on bituminous surfaceproviding and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per irc:35-2015 .the finished surface to be level, uniform and free from streaks and holes. rates are inclusive of all taxes, royalty,etc. all t&p/machine material and labour required for proper completion of work. 2 provinding and laying of hot applied thermoplastic compound 5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 5 mm is exclusive applied glass beads as per irc 35 the finished surface to level , uniform and free from streak and holes (for repeated bar) 3 providing and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per irc 67:2012 made of high intensity grade sheeting vide clause 801.3, fried over aluminum sheeting type-iv 1.5 mm thick supported on a mild steel angle iron post 75mm x 75 mm x6 mm firmly fixed to the ground by means of properly designed foundation with m 15 grade cement concrete 45 cm x 45 cm x 60 cm below ground level as per approved drawing. the retro-reflective sheeting shall be tested for 3 year outdoor weathering test in indian conditions as per irc 67: 2012 & proof of the same in form of government report shall be uploaded with quoting tender. (ch. 27 new item 6)a) 90 cm equilateral triangle with diffinitation plate size (20 cm x 60 cm) (left hand curve) 4 reflective raised pavement marker providing and fixing of raised pavement markers (cat eye) type x-astmd-4956-04 avery dennision/3m(usa make) having moulded body of polycarbonate, asa, hips or abs able to support a load of 13.635 m.t. tested in accordance with astmd 4280 type h and other requirement mentioned in mort&h circular, its reflective lens made of micro prismatic lens (capable of providing total internal reflection of light), electronically welded to the body. the length, height and width of the body shall not exceed 130 mm, 20 mm and 105 mm respectively, the area of each reflective surface shall not be less than 13 sq. cm . on each side sloping at the angle of 35 + 5 degree to the base to ensure maximum reflectively. it shall comply to specification of category a of mort&h circular no. rw/nh 33023/10/97-do-iii dated 11.06.97 lenses shall be moulded of methyl methecrylate conforming to astmd 788 or equivalent.with 7 years warranty. rate shall be inclusive of all taxes, royalty, etc. all t&p/ machine material and labour required for proper completion of work. (ch. 27 new item 10)