providing and fixing various items for road furniture in industrial area ph-i, chandigarh-applicator machine fitter with profile shoe, glass beads dispenser, propane tank heater and profile shoe heater, driven by experienced operator onroad surface including cost of material, labour, t&p, cleaning the road surface of all dirt, seals oil grease and foreign material etc. complete as per direction of engineer-in-charge and accordance with applicable specifications ( dsr 16.62 ) 2 providing and fixing reflective 3m or its equivalents raised pavement marker with moulded shanks made of polycarbonate and abs moulded body and reflective panelswith micro prismatic lens capable of providing total internal reflection of the light entering ( visible at night and in rainy conditions ) the lens face and shall support a load of 16000kg tested in accordance to astm d 4280 tape h and complying to specification category a of morth circular no. rw / nh / 33023 / 10-97-do iii dated 11.06.97. the height, width, length shall not exceed 50x100x100mmand with minimum reflective area of 13 sqcm on each side and the slopeto the base shall be 35+ / -5 degree. the strength of detachment of the integrated cylindrical shanks ( diameter not less than 19+ / -2mm and height not less than 30+ / - 2mm ) from the body is to be a minimum value of 500kg. the rates also includes cleaning of road surface andfixing will be by drilling holes on the road for the shanks to go inside, without nails and using epoxy resin based adhesive as per manufacture’srecommended andcomplete in all respect to the entiresatisfaction of engineer-in-charge 3 providing and fixing 3-m or equivalentsdual-directional delinator made out of 16 gauge m.s. rectangular pipe of size 25 x 68mm and of length 600mm. pipe stove enamelled and baked to 120?c powder coated.head made outof abs plastic rectangularmoulded with flat face provided with high intensity prismatic reflectors of colour ( white / yellow / red ) of size 100 x 125mm with additional 2 reflective strips of 25mm wide.embedded in cc 1:2:4 of block size of 9” x 9” x6”complete in all respect to theentire satisfaction of engineer-in-charge. 4 providing and fixingfive arrow reflective sign board plate only made out of 2mm thick crc sheet of size 900 x 250mm welded to the frame of same size made out of 25mm square hollow pipe of 16 guage sheet.the entire board is to beprocessed by stove enamel paint to make it weather resistance.front side of board sheet shall be covered with white colour retro reflective sheet tape of type iv engineering grade sheeting base along with five no arrows of 175mm high made out of same grade in red colour complete in all respect and to the entire satisfaction of engineer-in-charge.