tender for repairs to 5 cusec x 15mtr head horizontal split casing pumping unit-iii along with allied mechanical works at lis dulmachak-i. , decoupling of 5 cusec x 15 meter head discharge pump unit no iii from 50 hp motor and then dismantling the pump from the base frame. carriage & shifting of dismantled pump on head load to roadside using manual labour and then to workshop by carriage vehicle. repair to 5 cusec x 15 meter head discharge split casing pump of pumping unit no iii of lift irrigation station, dulmachak-i at workshop by dismantling and extraction of all worn out/damaged parts i.e. pump shaft, impeller, bearings, sleeves, bush, check nuts, nuts & bolts, gland plate, gland studs. properly cleaning the internal surface of pump casing. repairing of pump shaft by balancing ,brazing and turning to bearing size and threading at position of check nuts. repairs to impeller by filling cavities, cracks and finishing to original size. providing and fitting 2 nos of new bearing on driving and non-driving end of the pump, 1 nos check nuts, nuts & bolts, fabrication of 2 nos new gland plate with providing and fitting of 2 nos new gland studs on ends of pump. repair to bearing housing on driving and non-driving end of pumping unit by providing and fitting of bush, turning and fitting of bush to make inner diameter of bearing housing suitable for fitment of bearing. reassembling all parts of pump with proper greasing of bearings and providing and fitting of gasket sheet between upper and lower part of the pump. providing and fitting of graphite packing of suitable size on both ends of pump. job also includes providing of 2 kg graphite packing spare at site for routine use. shifting of repaired pumping unit on site and fitting of pumping unit on base frame. alignment of the pumping unit. repair to 200 mm dia sluice valve of unit no. iii, installed at lift irrigation station dulmachak - i, by way of cutting of nuts and bolts around the sluice valve with gas cutter. compl