|
| 1 | Supply of MS Dismantling joint with rubber compression ring and adjustable follower flanged complete assembled unt with galvanised stad and nuts. Size 400 mm Dia. |
| 2 | Supply of M.S. Flange (slipper type) as per IS-6392 TABLE 17 Thickness -20mm -22mm, 400 mm Dia |
| 3 | Supply of M.S. blank Flange as per IS-6392 TABLE 20 for 50 mm to size & for 200 mm & above as IS -6329 (Table-14) thickness 20mm-22mm, 400 mm Dia |
| 4 | Installation charge for 400 mm dia Dismantling joint as per T.S. & direction of EIC. |
| 5 | Maintenance and overhauling of isolating sluice valve/butterfly valve after dismantling it from delivery pipe line and checking part by part, cleaning, lubricating and thorough servicing the valve. This job includes labour charges, consumables like rubber gasket, sundry cleaning materials, lubricants and replace damaged parts as per instructions (spares cost excluded) & refitting of all parts with proper allignment as per instruction. For valve dia 300 mm to 600 mm |
| 6 | Manufacture and supply of pump/valve spares/components as per specification, drawing or existing one with proper tollerance and finish as per direction. |
| 7 | Transmission shaft/head shaft/impeller shaft/valve shaft (Material: Forged steel C40 IS-1570) |
| 8 | Bowl bush/valve bush (Material: GM Grade LTB 2&5 IS 318) |
| 9 | Supply fitting fixing of SS (AISI 304) nuts, bolts, washers dia 10 mm to 20 mm Length upto 75 mm |
| 10 | Supply of Gear Oil as per direction of Engineer in charge. (For Actuator's Gear box) |
| 11 | Vacuum pump-motor base/foundation frame renovation part |
| 12 | Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. Pakur Variety |
| 13 | Plaster (to wall, floor, ceiling etc.) with sand and cement mor-tar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course scaffolding staging where necessary (Ground floor) [Excluding cost of chipping of concrete surface)a) With 1:4 cement mortar.ii) 20 mm thick plaster. |
| 14 | Supply of M.S PLATE AS PER IS : 2062 -2011/Latest Revision, Make : SAIL/ TATA/JINDAL Above 2 mm upto 10 mm thickness |
| 15 | Supply of I.S.A as per IS : 2062 -2011/Latest Revision, Make : SAIL/TATA/JINDAL Upto 100x100 x different thickness |
| 16 | Welding, grinding, cutting charge for renovation of vacuum pump foundation as per T.S. & direction of EIC. |
| 17 | Supply fitting fixing of SS (AISI 304) nuts, bolts, washers dia 10 mm to 20 mm Length upto 75 mm |
| 18 | Supply of Epilux zinc phosphate primer grey(610) |
| 19 | Supply of Synthetic enemal paint (IS 2932) |
| 20 | Painter charge for Painting of vacuum pump-motor base/foundation frame.. |
| 21 | Less: @10% for scrap materials (Sl No.: 6,7,15) |
| 22 | Cess @ 1% |
| 23 | Added GST@ 18% Please Enable Macros to View BoQ information |
