|
| 1 | Dismantling steel work in built up sections in angles, tees, flats and channels including all gusset plates, bolts, nuts, cutting rivets, welding etc. including dismembering and stacking within 50 metres lead. |
| 2 | Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead. |
| 3 | Brick work with Ist class common burnt clay F.P.S.(non modular) bricks in superstructure above plinth level upto floor V level in all shapes and sizes in : |
| 4 | Cement mortar 1:4 (1 cement: 4 coarse sand) |
| 5 | Centering and shuttering including strutting, propping etc. and removal of form for: |
| 6 | Lintels, beams, plinth beams, girders, bressumers and cantilevers. |
| 7 | Reinforcement for R.C.C. work including straightening, cutting, bending,placing in position and binding all complete. Above Plinth level |
| 8 | Thermo-Mechanically Treated bars |
| 9 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering --All work upto plinth level: |
| 10 | 1:2:4 ( 1 Cement: 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) |
| 11 | 15 mm cement plaster on rough side of single or half brick wall of mix: |
| 12 | 1:4 (1 cement : 4 fine sand) |
| 13 | Providing and applying white cement based putty of average thickness 1mm,of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. |
| 14 | Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface |
| 15 | Water thinnable cement primer |
| 16 | Finishing walls with water proofing cement paint of required shade : |
| 17 | New work (Two or more coats applied @ 3.84 kg/10 sqm) |
| 18 | Steel work welded in built up section/framed work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using steel etc. as required. |
| 19 | grating, frames, guard bar, railing, brackets, gates and similar works. |
| 20 | Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal,complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required with |
| 21 | Precoated galvanised iron profile sheets 0.50 mm thick |
