Tender For Ranny Ramapuram Devaswom In Aranmula Group-Urgent Repair And Maintenance To Nadapandal And Certain Works.- Demolishing cement concrete manually / by mechanical means including disposal ofmaterial within 50 metres lead as per direction of Engineer - in-Charge.Nominalconcrete 1:4:8 or leaner mix ( including equivalent design mix) 3 Dismantling roofing including ridges, hips, velleys and gutters etc., and stacking thematerial within 50 metres lead of :Asbestos cement Sheet 4 Dismantling doors, windows and clerestory windows (steel or wood ) shutterincluding chowkhats, architrave, holdfasts etc. complete and stacking within 50metres lead:Of area 3 sq. metres and below 5 Dismantling old plaster or skirting raking out joints and cleaning the surface forplaster including disposal of rubbish to the dumping ground within 50 metres lead. 6 Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.)trusses etc., including cutting, hoisting,fixing in position and applying a priming coatof approved steel primer, including welding and bolted with special shaped washersetc. complete 7 Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coatedthickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade,5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metreor as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/selftapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch inhorizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters andtrusses and including cutting to size and shape wherever required. 8 Solid block masonry using pre cast solid blocks ( Factory made) of size 30x20x20cmor nearest available size confirming to IS 2185 Part I of 1979 for super structure up tofloor two level thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etccomplete 9 Repairs to plaster of thickness 12 mm to 20 mm in patches of area 2.5 sq meters andunder, including cutting the patch in proper shape, raking out joints and preparing andplastering the surface of the walls complete, including disposal of rubbish to thedumping ground within 50 meters lead:With cement mortar 1:4 ( 1 cement : finesand) 10 12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) 11 Providing and laying in position cement concrete of specified grade excluding thecost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarsesand (zone-III)derived from natural sources : 4 graded stone aggregate 20 mmnominal size derived from natural sources) 12 Finishing walls with Acrylic Smooth exterior paint of required shade :Old work (Oneor more coat applied @ 0.90 ltr/10 sqm). 13 Painting with synthetic enamel paint of approved brand and manufacture of requiredcolour to give an even shade :One or more coats on old work 14 Providing 30 mm thick rigid PVC door with PVC frame with shutter including allcost ofmaterials, fitting charges and labour charges,etc.complete. 15 Providing and fixing PVC pipes, fittings including fixing the pipe with clamps at 1.00m spacing. This includes jointing of pipes & fittings with one step PVC solventcement and testing of joints complete as per direction of Engineer-in-Charge 32 mmdia 10Kgf/cm2- Internal work - Exposed on wall 16 Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipes,including jointing with PVC solvent cement - 110 mm dia Elbow 17 Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipes,including jointing with PVC solvent cement- 110 mm dia Bend 18 Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipesincluding jointing with PVC solvent cement 110x110x110 mm dia Tee 19 Providing and fixing white vitreous china pedestal type water closet (European typeW.C. pan) with seat and lid, 10 litre low level white P.V.C. flushing cistern, includingflush pipe, with manually controlled device (handle lever), conforming to IS : 7231,with all fittings and fixtures complete, including cutting and making good the wallsand floors wherever required:W.C. pan with ISI marked white solid plastic seat andlid 20 Providing and fixing controlled flush, low level cistern made of vitreous china withall fittings complete.10 litre (full flush) capacity - coloured 21 Providing and placing on terrace (at all floor levels) polyethylene water storage tank:ISI 12701 marked, with cover and suitable locking arrangement and makingnecessary holes for inlet, outlet and overflow pipes but without fittings and the basesupport for tank. 22 Providing asbestos corrugated sheets roofing up to any pitch and fixing with polymercoated J,or L hooks, bolts and nuts 8 mm dia. G.I plain and bitumen washers or withself drilling fastener and EPDM washers etc. complete (excluding the cost of purlins,rafters and trusses), including cutting sheets to size and shape wherever required. 23 Providing ridges or hips width 60 cm overall width plain G.S. sheet fixed withpolymer coated J or L hooks, bolts and nuts 8 mm dia G.I. limpet and bitumenwashers complete.0.80 mm thick with zinc coating not less than 275 gm/m2 24 Providing labour for Gate Maintenance. 25 Cleaning old painted surface have algae and other impurity using pressure washerincluding labour and hire charge of pump etc. Complete 26 Providing and fixing PVC pipes includings jointing of pipes with one step PVCsolvent cement, trenching, refilling & testing of Joints complete as per direction ofengineer in charge.110 mm dia 6Kgf/cm2 27 Supplying and fixing CP Health faucet good quality including cost of materials andlabour charges etc. complete as per the direction of site engineer-in-charge. 28 Supplying and fixing 200 mm Aluminium aldrop 29 Painting with synthetic enamel pait one coat in different colour of paint after scrapingand cleaning the surface of idols and ornamental work for Krishna, Ayyappa andGanapathi 30 Providing precast concrete ring for well.Concrete ring of 1.10 m outer dia, 0.10 mthickness and 0.35 m height.Cost and conveyance of all materials,labour charges forinsitu casting etc complete as per direction of Engineer in charge 31 Painting with Synthetic enamel paint two coats in defferent colours to theDwarapalaka idol of size 1.10x0.60 32 Labour for doors and window Maintenance
