Tender For Provision Of Salvage Store; 1 Excavating intrenches not exceeding 1.5mwide and not exceeding 1.5 m in depth and getting out in hard/dense soil . 2 Returning ,filling in ,including spreading ,levelling,watering and well ramming in layers not exceeding 25cm in hard dense soil. 3 Removing surplus excavated soil to a distance exceeding 5 km but not exceeding15 kmand depositing where directed 4 M & L for Treating the bottom and sides of excavation at the rate of 5 litres of emulsion per square metre of surface area 5 M & L for Treating the soil under plinth protection at the rate of 5 litres of emulsion per square metre of surface area 6 Plain cement concrete 1:4:8 type D2 using40 mm graded stone aggregate as in foundations ,fillling and mass concrete. 7 M&L for RCC design mix M-25 (20mm graded aggregate) in Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete 8 M&L for RCC design mix M-25 (20mm graded aggregate) in Columns, pillars, piers, posts and struts 9 M&L for RCC design mix M-25 (20mm graded aggregate) in Beams,cantilevers, bressummers, lintels over 1.5m span 10 M&L for RCC design mix M-25 (20mm graded aggregate) in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like 11 M&L for RCC design mix M-25 (20mm graded aggregate) in chajjas etc. 12 M&L for flat formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter for rough finished surfaces of concrete. 13 M&L for flat formwork to sides of pillars, posts, struts, piers, columns and stanchions for rough finished surfaces of concrete. 14 M&L for flat formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including sup- ports, overhangs, etc. also splays between floors and beams, etc.for rough finished surfaces of concrete. 15 M&L for flat formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping)for rough finished surfaces of concrete. 16 M&L for flat formwork to chullah hoods, chajjas, troughs and similar items including edges for rough finished surfaces of concrete. 17 M&L for TMT bars 10 mm dia over cut to length,bent to shape required, including cranking ,bending spirally for hooping for columns,hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia. 18 All as above, but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders 19 Precast cement concrete block masonrywith solid blocksexc 10 cm in width in PCC 1:2:4 type B-1 and setting in cement mortar 1:4 all as specified 20 M & LRendering in CM 1:3, 5mm thick on fair faces of brick work or concrete surfaces on ceiling complete all as specified. 21 M & L for preparation of newlyplastered surfaces and applying threecoats of white washon ceiling.surface all as specified. 22 M&L for Rendering with WPC in CM 1:4, 15mm thick on othe thanfair faces of brick work or concrete surfaces all as specified and directed. Note : WPC shall be measured and paid separately 23 Supply only Intergral waterproofing compound 24 M&L for Rendering in CM 1:6, 10mm thick on fair faces of brick work or concrete surfaces all as specified and directed. 25 M & L preparation newly plasteredof wall surfaces and applyingtwo coats of acrylic smooth exterior paint of required shade (applied @ 1.67ltr/10 Sqm) over and including priming coat of exterior primer @2.20 Kg/10 Sqm) all as specified . 26 M & L prepation of newly plastered wall surfaces and applyingtwo coats of distemper oil emulsion over over a coat of primer over 3mm thick wall care putty on wall all as specified and as directed . 27 M & L Hardcore of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface 28 M&L for Cement concrete type D- 2, 1:4:8 (40mm graded aggregate) in sub base of floor 75 mm thick 29 M & L for Screed bed or bedding layer of mortar 20 mm thick for laying floor finishes in CM 1:4 30 M & L for Machine cut cudappah stone slab 20-25mm thick over cement screed base,laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete 31 M &L for cudappah/ Kota stone slab 20-25mm thick in riser of steps, skirting, dado and pillar laid over cement screed and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete 32 M & L for cement concrete type c-2, 1:3:6 (40mm graded aggregate) 75 mm thick in plinth protection 33 M & L for Pressed steel frames for doors with one or more rebates including necessary fixing lugs, hinges, lock strike plate, etc., complete, as specified, supplied and fixed size of frame 125 x 60mm 34 S&F 40mm thick Flush shutters, solid core construction, with particle board core and plywood face panels, commercial type on both sides and both faces are covered with decorative face veneer with lipping/frame to match 35 Preparation of new wood or wood based surfaces over 10 cm width or girth and applying twocoats of synthetic enamel paint over a coat of pink primer. 36 S&F100mm long butt hinges, medium weight, cold rolled mild steel with brass/bronze hinge pin. 37 S&F 300mm Aluminium alloy, anodised, sliding door bolt with hasp, staple (bolt type) and fixing clips of sheet, cast or extruded sections and fixing bolts and sliding bolts of extruded sections or cast-aluminium alloy and fixed. 38 S&F 200mm longAluminium anodised, barrel tower bolts of extruded section and fixed 39 S & F Floor door stopper of aluminium alloy body and tongue, anodised, with hard drawn steel spring 40 S & F S&F 150 mm extruded aluminium alloy handles, fabricated type anodised asspecified and directed 41 S & F Steel ventilator with top hung shutter including hinges, steel peg stay, complete 42 Supply and application of single component, seamless, spray applied, hybrid elastomeric PU based material i.e Nitoproof 725 of Fosroc chemicals (or) sikalastic 590 of Sika India Pvt Ltd (or) equivalent in any approved make as approved by GE over a coat of primer i.e Nitoproof WB primer of Fosroc chemicals (or) diluted sikalastic 590 of Sika India Pvt Ltd (or) equivalent in any approved make as approved by GE, all as recommended by manufacturer ans as specified.Note:-(i) Average minimum DFTof PU based material shall be 1mm and shall be applied by using a Graco pump.(ii) PU based material shall process the following properties solids by volume -65%, tensile strength ASTM D412-1.75Mpa, density 1.3 g/ml, elongation ASTM D-412-350%, Adhesion to substrate concrete-1.9Mpa, resistance to water-10m pressure.(iii) Rate are deemed to be include for cleaning and preparation of surface to receive PU water proofing system including filling of cracks with cementitious repair mortars i.e renderoc CS of Fosrock chemicals (or) equivalent of approved make.(iv) 10 years of guarantee shall be provided. 43 M & L hydraulically pressed burnt clay tile plain of size 200x200x19/20mm machine made laid over & including cement mortar screed 15mm thick in CM 1:6 mixed with water proofing compound and jointed pointed in CM 1:3 mixed with 5%crude oil by weight of cement. 44 Supplyng and laying of XLPE insulated armoured heavey duty electric cable with aluminium conductor 1100 volts grade cross sectional area 6 sq mm 2 core including taking down userviceable cables all as directed. 45 Earth cushioning to UG cables using excavated soil riddled by using large sieve to separate the composite particles/roots etc and refilling in trenchesall as specified andas directed.Note:Punned thickness will be measured for payment. 46 Supply and lay burnt bricks sub-class B designation 75 for cable protection all as specified and as directed. 47 M&L for dismantling / cutting of existing road / path / hard standing cement concrete (unreinforced) in ground floors and pavings n.exc 15 cm thickness (below or above ground level) suitable for laying cable protection pipe 80 / 50 mm dia under the road / path / hard standing complete. 48 Material and labour for PCC (1:2:4) type B-2 (using 40 mm graded crushed stone aggregate) for making good the disturbed surface of road/path/hard standing by using cement contrete mortar 1:2:4 type B1, using 40 mm graded stone aggregate 0.45 mtr wide and 0.15 mtr thick complete all as specified and directed. including demolition of old PCC and removing the debris from site complete all as specified and as directed at site by the Engr-in-Charge. 49 M&L for concealed Point wiring one light/bell point controlled by one, one way switch complete with 1.5 sqmm single core PVC insulted FRLS cable 1100 volts grade multistrandedcopper conductor drawn through in and including 20mm dia PVC rigid non metallic conduit concealed with all accessories such as internal bend, end caps etc complete concealed in walls and surface in ceiling/roof/etc including 1.5 Sqmm single core PVC insulated FRLS cable 1100 volts grade with multistranded copper conductor cable as earth continuity conductor including fabricated branded modular metal flush box concealed in walls with suitable modular plate with cover with suitable screws for housing switches, socket outlets, fan regulators etc all as specified and as directed. Note: Cutting chases will be Measured and paid seperately. 50 All as per item No 49 herein before but one ceiling/exhaust fan point controlled by one, one way switch. 51 All as per item No 49 herein before but one05 Amps socket outlet pointon same board. 52 All as per item No 49 herein before but oneswitch socket outlet point 5 Amps on independent board. 53 All as per item No. 49 here-in-before but with copper conductor cable FRLS, 2.5 Sqmm for one 3 pin socket outlet, 15 Amps and including 2.5 Sqmm PVC insulated copper conductor cable as earth continuity conductor on independent board. 54 S&F Switch Modular 6A single pole, one way, 1 module complete all as specified and as directed. 55 S&F Switch Modular 16A single pole, one way, 1 module complete all as specified and as directed. 56 S&F Socket, 6A - 2/3 pin combined 2 module complete all as specified and as directed. 57 S&F socket Modular 6/16A 2/3 pin combined 2 module complete all as specified and as directed. 58 Supply and fixing LED lights fitting 1 x 18/ 20W, 220V,AC decorative box type with driver, holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete. Make - Bajaj, Crompton, Havells, Luker 59 Supply and fix MCB DB, SPN, 8 ways, double door, 240 volt, Isolated neutral bar with IP54 protection, door earthing arrangement with cement spill protector, mechanical impact strength IK09 complete. Make: L&T/Legrand/ Havells 60 Supply and fix MCB SP 6 to 32 Amps, 240Volts, 10 KA, B Curve complete. Make: L&T/Legrand/ Havells 61 Supply and fixing SPN 32 Amp rating 240 V, 10 KA C curve miniature circuit breaker (MCB) complete. Make: L&T/Legrand/ Havells 62 Supply and fix ceiling rose surface type bakelite 65 x 50mm with three terminals. 63 M & L for earthing complete with GIearth plate electrode 600 x 600 x 6.3 mm thick burried directly in ground (earth pit not less than 2.25m deep below ground level) with top edge of the plate not less than 1.5m below normal ground level, connected to GI earth lead 4 mm wire by means of bolts, nuts, check nuts/bracing and washers all as shown in electrical plate No. 3 of SSR Part-I and including necessary excavation and earth work in any type of soil, removal and refilling of soil and funnel with wire mesh and GI watering pipe 20mm dia, Chamber in PCC 1:3:6, type C1 using 20mm graded stone aggregate and 40mm thick cover in RCC 1:2:4, type B1 using 20mm graded stone aggregate and reinforced with 8mm dia TMT bars at 150mm c/c on both ways, with flush type handle with 16mm dia round bars and 15 mm dia GI pipe upto 7.5m for protection and connected to earthing test point all as specified or indicated including testing on completion.
