tender for work to smooth the power supply which gets disrupted due to accidental breakage under 33/11 kv power sub-station kumbhi and bara under power distribution division- raniya, kanpur dehat. loading 8.5 m long pcc poles from the power storage center jainpur on ones own vehicle and taking them to the work site and keeping them safely lifted (by unpaved/paved road). loading 11 meter stp pole from the power storage center jainpur on ones own vehicle, taking it to the work site and keeping it safely lifted (by unpaved/paved road). power line materials such as conductor clamps. nut-bolt washers lt cable, stonepad. the work of transportation of stayset xlpe abc etc. in ones own vehicle to the specified place (approximate distance 75 km) (by unpaved/paved road). pcc poles will be fitted with all accessories like cos arms by digging pits in place of broken/damaged poles. installing the earthing rod by tying the disc pin insulator etc. repo, lucknow, tying all the accessories as per requirement in the long span between the pre-built lines. strengthening by installing additional poles (stp) as per the prescribed standards/specifications. re-energization work done. the work of re-energizing the long span in the middle of the pre-constructed line by tying all the accessories as per requirement and strengthening it by installing additional poles (p.c.c.) as per the prescribed standard/specification of respo lucknow. installation of new section double pole in place of broken/damaged double pole. grouting work of pcc/stp pole as per respo standard. cement, ballast. maurang- supplying in the ratio of 1:2:4. repair work of section double pole. tightening the damaged stay by renosing it. tightening of loose wires of 33 kv line (each wire) tightening of loose wires of lt and 11 kv lines (each wire) straightening of slant poles of 33 kv line/11 kv line/lt line as per respo standard. after tying all the accessories, make the tax stand properly. 33/11: giving clearance to the trees of kv and lt lines by cutting them. acsr in 33/11 kv line. by spreading the weasel conductor and tying stringing and sagging insulators in all three phases, doing jumpering and earthing (each wire). replacement of damaged cross arm.