tender for water supply renovation work and building repairing of majhra health center - 1 [ page-11, it no. -6(a)]dismantling artificial stone flooring upto 50 mm. thick by carefully chiselling without damaging the base and removing rubbish as directed within a lead of 75 m.in ground floor including roof. 2 [ page-11, it no. -10]stripping off worn out plaster and raking out joints of walls, celings etc. upto any height and in any floor including removing rubbish within alead of 75m as directed.. 3 [ page-14, it no. -1]single brick flat soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints with local sand. 4 [ page-15, it no. -7(a)]brick work with 1st class bricks in cement mortar (1:4)(a) in foundation and plinth 5 ordinary cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement,if any, in ground floor as per relevant is codes (b) river bazree 6 o[ page-64, it no. -35]supplying, fitting & fixing 1st quality ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles includingroughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.(a) floor with sand cement mortar (1:4) 20 mm thick & 2 mm thickcement slurry at back side of tiles using cement @ 2.91 kg/sq.m & joint filling using white cement slurry @0.20kg/sq.m.(a) area of each tile upto 0.09 sq.m(i) coloured decorative. 7 [ page-64, it no. -35]supplying, fitting & fixing 1st quality ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles includingroughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.(b) wallwith sand cement mortar (1:4) 20 mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 kg/sq.m & joint filling using white cement slurry @0.20kg/sq.m.(a) area of each tile upto 0.09 sq.m(i) coloured decorative 8 [ page-104, it no. -13](a) m.s.or w.i. ornamental grill of approved design joints continuously welded with m.s, w.i. flats and bars of windows, railing etc. fitted and fixed with necessary screws and lugs in ground floor(ii) grill weighing above 16 kg./sq.mtr and above 9 [ page-105, it no. -15]supplying 1.5mm thick m.s. sheet fitted and fixed on one or both faces of m.s./ w.i. gate etc. with point welding at not more than 150mm apart complete in all respect as per design including cost of all labour and materials. 10 plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (ground floor). [excluding cost of chipping over concrete surface] a) with 1:4 cement mortar. 10mm.thick plaster 11 [ page-189, it no. -1]applying decorative cement based paint of approved quality after preparing the surface including scraping the same thoroughly (plastered or concrete surface) as per manufacturers specification. 12 [ page-200, it no. -1](a) priming one coat on steel or other metal surface with synthetic oilbound primer of approved quality including smoothening surfaces by sandpapering etc 13 [ page-200, it no. -2](a) painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : 14 neat cement punning about 1.5mm thick in wall, dado, window sill, floor etc. 15 add 18% gst = 16 add labour welfare cess @1% =