tender for aluminum work at nift jodhpur - providing and fixing aluminum work for doors, windows, ventilators and partitions with extruded built up standard tubular sections / appropriate z sections and other sections of approved make conforming to is: 733 and is: 1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required epdm rubber / neoprene gasket etc. aluminum sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, aluminum snap beading for glazing / paneling, c.p. brass / stainless steel screws, as per the directions of engineer-in-charge.powder coated aluminum ( minimum thickness of powder coating 50 micron ) 3 for shutters of doors, windows & ventilators including providing and fixing hinges / pivots and making provision for fixing of fittings wherever required including the cost of epdm rubber / neoprene gasket required as per the directions of estate engineer.powder coated aluminum ( minimum thickness of powder coating 50 micron ) 4 providing and fixing 12 mm thick prelaminated particle board flat pressed three layer or graded wood particle board conforming to is: 12823 grade l type ll, in panelling fixed in aluminum doors, windows shutters and partition frames with c.p. brass / stainless steel screws etc. complete of engineer in-charge.pre-laminated particle board with decorative lamination on both sides- 5 providing and fixing 4 mm thick acp sheet with pasting grow silicon pasting with pri laminated completed as per direction of engineer in-charge 6 providing and fixing glazing in aluminum door, window, ventilator shutters and partitions etc. with epdm rubber / neoprene gasket etc. complete as per the directions of engineer-in-charge . with float glass panes of 5 mm thickness ( weight not less than 12.50 kg / sqm ) 7 existing aluminum section material reuse dismantling & fixing aluminum section, including screw supporting and etc. as per direction of engineer in-charge.