tender for annual maintenance of main water works tosham road, hisar. “white washing, painting, flooring and wood work etc. in quarter no. 1 at 18 no. staff quarter at main water works tosham road, hisar; 1 [10.63.2]providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to is: 15622, of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqmincluding grouting the joints with white cement and matching pigments etc., complete. 2. size of tile 600x600 mm 2 [11.60]providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. 3 [11.64.1]distempering with oil bound washable distemper of approved brand and manufacture to give an even shade : 1. new work (two or more coats) over and including water thinnable priming coat with cement primer 4 [12.32.1.1.3]providing and fixing wire gauge shutters using stainless steel grade 304 wire gauge with wire of dia 0.5 mm and average width of aperture 1.4 mm in both directions for doors, windows and clerestory windows with necessary screws : 1.1.3. 35 mm thick shutters with isi marked m.s. pressed butt hinges bright finished of required sizekiln seasoned selected class of sheesham wood 5 [12.37.1]providing and fixing isi marked flush door shutters conforming to is : 2202 (part i) non-decorative type, core of block board construction with frame of 1st class hard wood and well matched commercial 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters: 1. 35 mm thick including isi marked stainless steel butt hinges with necessary screws 6 [13.3.2.2]providing and fixing pressed steel door frames conforming to is: 4351, manufactured from commercial mild steel sheet of 2.0 mm thickness, including hinges, jamb, lock jamb, bead and if required angle threshold of mild steel angle of section 50x25 mm, or base ties of 2.00 mm, pressed mild steel welded or rigidly fixed together by mechanical means, including m.s. pressed butt hinges 2.5 mm thick with mortar guards, lock strike-plate and shock absorbers as specified and applying a coat of approved steel primer after pre-treatment of the surface as directed by engineer-in-charge: 2.2. profile c fixing with carbon steel galvanised dash fastener of required dia and size (to be paid for separately) 7 [9.32.1]providing and fixing uv stabilised fibreglass reinforced plastic sheet roofing up to any pitch, including fixing with polymer coated `j` or `l` hooks, bolts and nuts 8mm dia. g.i plain/bitumen washers complete but excluding the cost of purlins, rafters, trusses etc. the sheets shall be manufactured out of 2400 tex panel rovigs incorporating minimum 0.3% ultra-violet stabiliser in resin system under approximately 2400 psi and hot cured. they shall be of uniform pigmentation and thickness without air pockets and shall conform to is 10192 and is 12866.the sheets shall be opaque or translucent, clear or pigmented, textured or smooth as specified. 1. 2 mm thick corrugated (2.5 or 4.2 or 6) or step-down (2 or 3 or 6 ) as specified