supply of ferritic steel sheet 12x1250x3000mmferritic steel sheet 12x1250x3000mm,ferritic steel sheet 12x1250x3000mm., as per drawing: is:6911-1992,grade x04c r12 (405), surface finish 2d as per table 8., packing instruction: stainless steel sheets, coils and plates:- (a) stainless steel (austenitic & ferritic steel) coils. the coil shall be prote cted in reasonably good condition to withstand normal handling hazard during trans it with the following provision as the barest minimum: i) coil should be wrapped with a layer of water proof paper through out whole length. ii) coil should be wrapped with a layer of biodegradeable sheet. iii) outer & inner of coil should be wrapped with gi she et. iv) side of the coil should be covered with card board sheet. v) after this whole coi l should be wrapped with biodegradeable plastic sheet of suitable thickness. vi) the inner edge of the coil should be protected by gi ring followed by another iron ring. vii ) outer edge of the coil should be wrapped with gi ring. viii) coil should be securely st rapped with minium 5 steel bands through the eyes of the coil and minium 3 steel bands on the circumference of the eye. ix) whole coil should be mounted on wooden blocks f or easy lifting/stacking. x) the sheets in coil form for thickness 2mm and above shall h ave: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 ton nes xi) the sheets in coil form for thickness below 2mm shall have: inner dia of coil 450 -650mm outer dia of coil 1000-1300mm weight of coil 5.0 - 10 tonnes. (b) stainless steel ( austenitic & ferritic steel plates/sheets) i) the sheets/plates shall be supplied in bundle s of optimum weight: 2mt+/-10% & each sheet/plate shall be seprated with a layer of wa ter proof paper, after this the whole bundle should be wrapped with double layer of water proof paper and a biodegradeable plastic sheet of suitable thickness. a metal pr otection in edges should also be provided. ii) all bundles shall ha