supply of ferritic steel coil 2x1250mmferritic steel coil 2x1250mm,ferritic steel coil 2x1250mm., as per drawing: rdso spec. no. c-k201, grade x2crni12 (409m) table 1&2, heat treatment condition 2b as per table-5., packing instruction: stainless steel sheets, coils and plates:- (a) stainless steel (austenitic & ferritic steel) coils. the coil shall be protected in reasonably good condition to withstand normal handling hazard during transit with the following provision as the barest minimum: i) coil should be wrapped with a layer of water proof paper through out whole length. ii) coil should be wrapped with a layer of biodegradeable sheet. iii) outer & inner of coil should be wrapped with gi sheet. iv) side of the coil should be covered with card board sheet. v) after this whole coil should be wrapped with biodegradeable plastic sheet of suitable thickness. vi) the inner edge of the coil should be protected by gi ring followed by another iron ring. vii) outer edge of the coil should be wrapped with gi ring. viii) coil should be securely strapped with minium 5 steel bands through the eyes of the coil and minium 3 steel bands on the circumference of the eye. ix) whole coil should be mounted on wooden blocks for easy lifting/stacking. x) the sheets in coil form for thickness 2mm and above shall have: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 tonnes xi) the sheets in coil form for thickness below 2mm shall have: inner dia of coil 450-650mm outer dia of coil 1000-1300mm weight of coil 5.0 - 10 tonnes. (b) stainless steel (austenitic & ferritic steel plates/sheets) i) the sheets/plates shall be supplied in bundles of optimum weight: 2mt+/-10% & each sheet/plate shall be seprated with a layer of water proof paper, after this the whole bundle should be wrapped with double layer of water proof paper and a biodegradeable plastic sheet of suitable thickness. a metal protection in edges should also be provided. ii) all bundles shall have a