supply of face milling cutter rhface milling cutter rh,face milling cutter rh for milling of axle ends. the milling cutter should have 16 pockets (15 pockets for milling inserts and one pocket for wiper insert) and we ight of the cutter shall be 25 kgs aprox. the cutter should be complete with adjustabl e wedges and shims to support the inserts. the cutter should be capable of milling 10m m material per pass with a surface finish of 6.3ra. milling cutter should be supplied alo ng with the following spares (1) shim -150 nos. (2) shim screw -150 nos. (3) axial support ( rh)-25 nos. (4) wedge for inserts-25 nos. (5) wedge for axial support-25 nos. (6) wedge sc rew- 150 nos. make: sandvik, kennametal, walter only ] , face milling cutter lh for milling of axle ends. the milling cutter should have 16 pockets (15 pockets for milling inserts and one pocket for wiper insert) and we ight of the cutter shall be 25 kgs approx. the cutter should be complete with adjustab le wedges and shims to support the inserts. the cutter should be capable of milling 10 mm material per pass with a surface finish of 6.3ra. milling cutter should be supplied al ong with the following spares (1) shim -150 nos. (2) shim screw -150 nos. (3) axial support (lh)-25 nos. (4) wedge for inserts-25 nos. (5) wedge for axial support-25 nos. (6) wedge sc rew- 150 nos. make: sandvik, kennametal, walter only. ]