equipments in mechanical engg , supply of equipments in mechanical engg ( for technical specificationsrefer nit ) , temperature measurement kit: activities perform: construct a circuit to measure temperature of liquid using thermocouple and trd plot the graphical relationship between input and output parameters. , behavior of proximity sensors: activities perform: observe the behavior of inductive proximity sensor and capacitive proximity sensor for different material samples. interface relay and buzzer with sensors to test the output. , lvdt trainer kit: construct a circuit for measurement of linear displacement using lvdt. plot the graphical relationship between input and output parameters. , construct a circuit to obtain vi characteristics and response characteristics of photo conductive cell (ldr) , construct a circuit to measure the speed of the motor using optical sensor , performance of ultrasonic and moisture sensors: interface ultrasonic sensor with arduino and measure the distance of the object. interface moisture sensor with arduino and measure the moisture content in the soil , construct a circuit to get on/off control on dc motor using push button, spst, spdt and limit switch. , construct a circuit to get on/off control on dc motor using transistor and relay , forward and reverse control of ac motor: activities to perform: connect forward reverse control switch to change the direction ofrotation of three phase induction motor demonstrate the forward and reverse operation of motor measure the no-load current in each phase using tongue tester (clamp meter) with digital ammeter with 1 hp 3 ph induction motor clamp meter. , pneumatic circuit for double acting cylinder connect a pneumatic circuit to control double acting pneumatic cylinder using 5/2 solenoid valve discuss the behavior of cylinder as linear actuator compressor. , observe the behavior of hydraulic motor: activities to perform: connect a hydraulic circuit to control hydraulic motor observe the behavior of hydraulic motor. , servo motor control with an arduino: connect and arduino based circuit to sweeps the shaft of servo motor back and forth across 180 degree interface potentio meter with arduino and based on its position get the control of servo motor shaft. => limited