supply of ferritic steel sheet 3x1250x2100mmferritic steel sheet 3x1250x2100mm,ferritic steel sheet 3x1250x2100mm., as per drawing: rdso spec. no. c-k201, gra de x2crni12 (409m) table 1&2, heat treatment condition 2b as per table-5., packing instructi on: stainless steel sheets, coils and plates:- (a) stainless steel (austenitic & ferritic steel) coils. the coil shall be protected in reasonably good condition to withstand normal handling hazard during transit with the following provision as the barest minimum: i) coil should be wrapped with a layer of water proof paper through out whole length. ii) coil should be wrapped with a layer of biodegradeable sheet. iii) o uter & inner of coil should be wrapped with gi sheet. iv) side of the coil should be c overed with card board sheet. v) after this whole coil should be wrapped with biod egradeable plastic sheet of suitable thickness. vi) the inner edge of the coil shoul d be protected by gi ring followed by another iron ring. vii) outer edge of the coil should be wrapped with gi ring. viii) coil should be securely strapped with minium 5 steel bands through the eyes of the coil and minium 3 steel bands on the circumfer ence of the eye. ix) whole coil should be mounted on wooden blocks for easy liftin g/stacking. x) the sheets in coil form for thickness 2mm and above shall have: inner dia of coil 450-800mm outer dia of coil 1000-1300mm weight of coil 2.4 - 10 tonnes xi) the sheets in coil form for thickness below 2mm shall have: inner dia of coil 450-650mm o uter dia of coil 1000-1300mm weight of coil 5.0 - 10 tonnes. (b) stainless steel (austeniti c & ferritic steel plates/sheets) i) the sheets/plates shall be supplied in bundles of optimum weight: 2mt+/-10% & each sheet/plate shall be seprated with a layer of wate r proof paper, after this the whole bundle should be wrapped with double layer o f water proof paper and a biodegradeable plastic sheet of suitable thickness. a me tal protection in edges should also be provide