tender for material supply for mgnregs work , item rate , stone for masonry work , quarry waste , interlocking c c paver block (80 mm thick, m-30) , stone aggregate (single size):06 mm nominal size , stone aggregate(single size):20 mm nominal size , stone aggregate (single size):10 mm nominal size , stone aggregate (single size): 40mm nominal size , gravel 5 mm to10 mm , gravel 1.5 mmto 2 mm , coarse sand (zone iii) , fine sand (zone iv ) , portland cement , twisted steel/deformed bars , wall form panel 1250 x 500 mm , corner angle 45x45x5 mm 1.50 m long , 100 mm channel shoulder 2.5 m long , double clip (bridge clip) , single clip , m s tube 40 mm dia , royalty for good earth , structural steel such as tees,angle , channels and r.s.joists , red oxide zinc chromate primer , adjustable telescopic prop 3 m (2.02-3.75m) , beam clamp 300-380 mm (450-1070 mm ) , solid blocks of size 30x20x15 cm , water thinnable cement primer for interior wall surface , having voc content less than 50 gms/litre , plastic emulsion paint , mild steel tubes hot finished welded type , synthetic enamel paint in black or chocolate shade , gi trafford profile sheet 0.35 mm thick , bitumen washer , stainless steel screws 50 mm , galvanised wire mesh of average width of apertune 1.4 and nominal dia of wire 0.63 mm , wire nails , epoxy paint , mild steel sheets for tanks , iron pintels including weldded pin , mild steel sheets with bolts and nuts to rest on pintels , mild steel hooks , oxidised mild steel handles 125 mm , oxidised mild steel screws 25 mm , mild steelbutt hinges 100x 58 x 1.90 mm , bright finished or black enameled mild steel screws 40 mm , flats up to 10 mm in thickness , vitrified floor tile 60 x 60 cm , stainless steel kitchen sink without drain board 470 x 420 mm bowl depth 178 mm , c. i bracket for wash basin and sinks , semi rigid pvc waste pipe for sink and wash basin 32 mm dia with length not less than 700 mm i/c pvc waste fittings , pvc pipe 20 mm outer dia 10 kgf/cm2 , pvc pipe 32 mm outer dia 10 kgf/cm2 , pvc pipe 63 mm outer dia 6kgf/cm2 , pvc elbow 63 mm dia , pvc bend 63 mm dia , pvc tee 63 x 63 x 63 mm dia , pvc reducer 63 x 50 mm dia , pvc pipe 160 mm outer dia 4 kgf/cm2 , mild steel round bar above 12 mm dia , rawl plug 50 mm (designation 10 nos) , second class kail wood in planks , second class kail wood in scantling , hire charges of concrete mixer 0.25 to 0.40 cum with hopper , vibrator (needle type 40 mm ) , welding by electric plant