tender for design supply and labour job for instalilation testing commissioning and successful trial run of 300 mts capacity butter deep freezer at jabalpur sahakari dugdh sangh mydt tender for design supply and labour job for instalilation testing commissioning and successful trial run of 300 mts capacity butter deep freezer at jabalpur sahakari dugdh sangh mydt , design and supply of refrigeration system along with all equipment and accessories for 300 tons capacity butter deepfreezer. , insulation panel & door. with all accessories for 300 tons capacity butter deep freezer: quantities required for four chambers and one ante room cum passage as shown in layout plan and technical specifications given in clause- 3. work scope, technical specifications and bill of quantities. , refrigeration system with all accessories including required capcity compressor, condensing unit, cooling unit, refrigeration control, copper pipes, fittings and refrigerant for first charge for 300 tons capacity butter deepfreezer: no. of units of equipment and accessories required for refrigeration system for four chambers each of 75 tons(total 300 tons) are to be designed as shown in layout plan and technical specifications given in clause- 3 of work scope, technical specifications and bill of quantities. , electrical equipment and accessories for operation ofthe refrigeration system : out going feeder at existing pcc panel and laying of cabel up to for power supply,mcc control panel , electrical hardware, incoming electrical fittings/accessories, outgoing electrical fittings/accessories, digital display and electrical control cable etc: no. of electrical equipment and accessories required for refrigeration system for four chambers each of 75 tons(total 300 tons) are to be designed as shown in layout plan and technical specifications given in clause- 3. work scope, technical specifications and bill of quantities. , civil construction materials, steel for rcc, ms supports, pipes, poles, trenches etc: refer-technical specifications given in clause- 3. work scope, technical specifications and bill of quantities , labour job forinstallation, testing, commissioning, trial run, training to staff of complete equipment and accessories and civil construction work offered fordeepfreezer , all equipment installation properly as per layout. copper piping to mechanically interconnect as per diagram submitted, refrigeration suction line.electrically interconnect all equipment & machinery from control panel with earthling. vacuumed testing for cold storage, pressure testing for cold storage & refrigeration system by nitrogen. complete plant commissioning as per scope of work and performance , civil work : scope of work of civil work for 300 mt butter cold room plate form finish plinth area size from ffl – 38 meter (l) x 19.5 meter (w) x 1 meter (h) sequence of work scope as follows, 1. deep excavation from finish floor area up to 1.5 mtrs or up to hard soil and filling up to 2.5 mtrs high, hard murum and stone etc. 2. r.c.c column 300x600 around the plate form shown in drawing for future covered and deep to hard strata 2.5 meter 3. r.c.c column 300x300 up to plinth 1meter from ground level and deep up to hard strata 2.5 m 4.filling of murrum and boulder with earthen material 5.minium 4” p.c.c to be provided after filling 2) minimum 6” r.c.c. to be provided after filling. 3) minimum 3mm tarfelt sheet along with bitumen to be provided. 4) minimum 75mm one layer of bare puff provided along with bitumen. 5) minimum 3mm tar felt sheet along with bitumen to be provided. 6) minimum 2” pcc to be provided on tar felt sheet. 7) minimum 20mm thick kota stone with duly polished to be required. 8)the design of r.c.c structure shall be done as per actualas per s.b.c 9)necessary foundations for equipment based on the details provided by the equipment bidder. patch up/finishing works, specifically for the cut- openings in the wall, ceiling etc. masonry cable trench in plant room.