tender for purchase of equipments for ece department-- 1 function generator • frequency range: 0.1 hz to 5 mhz• display: 4 to 6 digit led display• output waveforms: sine, triangle, square, ± pulse, ± ramp.• amplitude: 0–20 vpp.• rise time: 2 strain gauge trainer kit•ac mains power supply: 230 v ±10%, 50 hz• metal foil strain gauge mounted onbeam/cantilever.• strain measurement under applied load.• wheatstone bridge arrangement.• signal conditioning and amplification circuit.• instrumentation amplifiers with 3½ digit display for strain / output voltage.• zero and gain adjustment controls.• provision for applying calibrated loads.• table-top trainer with labelled panel.• test points for signal measurement.• built-in dc power supplies and wooden closed cabinet.• supplied with patch cords and user manual. 3 temperature measurement kit• sensors:rtd (pt-100), thermocouple (fe-k/j-type), and/or thermistor (ntc).• display: 3½ digit led/lcd digital display(typically 200 mv fsd).• temperature source: portable water kettle orheater block.• signal conditioning: on-board circuitry foramplification, linearization, and cold junctioncompensation.• test points: multiple 2 mm / 4 mm banana sockets for monitoring input/output signals.• power supply: 230 v ac, 50 hz, single-phase.• accessories: glass thermometer, 10 k ntcthermistor probe, k-type thermocouple probe,patch cords and user manual. 4 cathode ray oscilloscopebandwidth: dc to 30 mhz (-3 db)- sensitivity: 1 mv/div to 5 v/div- display modes: ch1, ch2, dual(chop/alt), add, sub- timebase: 0.2 μs/div to 0.5 s/div(essential for slow bio-signals)- magnification: x 10 sweep magnifier- triggering: alt triggering, auto, norm, - tv-v/h with source selection (ch1, ch2, line, ext).- input impedance: 1 mohm || 25pf- included accessories: two 60 mhzpassive probes, power cord, anduser manual please enable macros to view boq information = limited