inspection of condenser tubes flaring and torque setting by using special tools & tube sheets, cleaning /degreasing and epoxy coating to thethickness of 1500 microns on condenser tube sheets of the condenser and cleaning, sand blasting and painting of cooling water box inlet & outlet side of thecondenser lhs & rhs, front & rear sides, tie rods etc. during coh- 2024-2025.; 1 charges for one side either front/back side of lhs/rhs inspection of condenser tube and tube sheet for internal repair by using special tools and methods. 2 condenser water box epoxy coating: cleaning, degreasing and preparing exterior surface of the condenser water box by grid blasting and apply a epoxy coating to an average thickness of 1500 microns. 3 charges for surface cleaning for the removal of existing old partly hard sticking coated paint from cooling water box inlet & outlet side of the condenser, left hand side & right hand side, front & rear sides, tie rods etc., for carrying out sand blasting process. 4 charges for sand blasting of cooling water box inlet & outlet side of the condenser left hand side & right hand side, front & rear sides, tie rods etc., (sand contractor’s scope). 5 painting of cooling water box inlet &outlet side of thecondenser lhs & rhs, front & rear sides, tie rods etc. with black paint (paint contractor scope). 6 cost of epoxy coating material/m2(for sl no.02) 7 material chargesfor sand /m2(for sl no.04) 8 material chargesforenamel paint /m2 (for sl no.05) 9 charges for consumables and t&p’s item sl.no:1 to 5