tender for repairing and finishing works in ae, je room and store room at canal colony, cantt road, lucknow.- 12 mm cement plaster in single coat in building finished even & smooth 1 cement : 4 coarse sand including all l/m, t&p etcincluding the dismantling existing plaster, including disposal of refuseas directed by theengineer-in-charge with in distance of 60m. 2 scraping old white or colour wash including disposal of refuse as directed by engineer- in- charge with in a distance of 60m. 3 providing and applying white cement based putty of average thickness 1mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete 4 one priming coat and two coat oil bound distemper includingsupply of all materials, labour and t&p etc.required for proper completion of work. 5 paintingor varnishing on iron work in small areas or new wood work with one coat of ready mixed priming paint & two coat of approved superiorquality ready mixed paint of clear synthetic varnish including supply of all materials ,labour, t&p etc required for proper completion of work .(paint to be used should conform to the isi no -103-1950.) 6 providing and fixing isi marked flush door shutters conforming to is : 2202 (part i) decorative type, core of block board construction with frame of 1st class hard wood and well matched teak 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters. 35 mm thick including isi marked stainless steel butt hinges with necessary screws 7 providing and fixing 19mm thick both side balancing lamination factory pressed bwp grade marine ply as per is 710 of approved brand boxes, shelves, racks, almirah, cupboard and drawer etc. including necessary nails,screws etc. complete as per direction of engineer-incharge. 8 providing and fixing stainless steel fancy handle of approved make fixed with ss screws etc. complete as per direction of engineer-in-charge. 200 mm 9 providing and fixing stainless steel soft closing spring hinges at 0 degree hinges (hydraulic type) of approved make/brand to cupboard shutters with full threaded steel screws including making necessary recess in board and finished etc. complete as per direction of engineer-in-charge. 10 providing & fixing uv stabilised fiberglass reinforced plastic sheet roofing up to any pitch, including fixing with polymer coated j or l hooks, bolts & nuts 8mm dia. g.i plain/bitumen washers complete but excluding the cost of purlins, rafters, trusses etc. the sheets shall be manufactured out of 2400 tex panel rovigs incorporating minimum 0.3% ultra-violet stabiliser in resin system under approximately 2400 psi and hot cured. they shall be of uniform pigmentation and thickness without air pockets and shall conform to is 10192 and is 12866.the sheets shall be opaque or translucent, clear or pigmented, textured or smooth as specified. 2 mm thick flat