|
| 1 | SUPPLY OF FOLLOWING NON CENTRALISED MATERIAL |
| 2 | Bracing Clamp SP-72 |
| 3 | Holding Clamp for ST Pole SP-72 with nut and bolt |
| 4 | Stay clamp for SP-72 with N/b |
| 5 | IPC with aluminium bail for earthing |
| 6 | 11 KV Cable Ties for Pin insulator |
| 7 | 11 KV IPC for Covered conductor to Covered Conductor |
| 8 | 11 KV IPC for Covered conductor to Bare Conductor |
| 9 | 11 KV Mid Span Jointing Kit |
| 10 | 11 KV AAAC AL-59, 70 Sq mm covered Conductor |
| 11 | 11 KV tension clamp with bail & IPC |
| 12 | LABOUR CHARGE |
| 13 | Fabrication of MS Channel angle iron etc in required sizes with drilling of holes upto good finish for top channel ,bracing and spec ial type bracket etc. as per RESPO schedule and local approced drawing. |
| 14 | Excavation of earth for stay pit of size 0.6x0.6x1.2 mtr in all types of soil including proper dressing of sides and ramming of bott om including getting out the excavated soil and disposal of surplus excavated soil as directed complete work |
| 15 | Fixing,tightening and nozzling of stay with pole and stay rod on required tension as per drawing/manual in 11 KV Line |
| 16 | Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block includ ing cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as pe r RESSPO Manual. |
| 17 | Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all types of soil including prop er dressing of sides and ramming of bottom including etting out the excavated soil and disposal of surplus excavated soil as directe d complete work |
| 18 | Erection of SP-72 single support pole in proper level and alignment along with fixing of all accessories like top channel,& clamps a s per RESPO manual |
| 19 | Grouting of pole in size 0.45x4.45x1/9 of the support in CC ration 1:4:8(1 cement:4 graded stone20 mm niminal size: 8 coarse sand) b lock including cost of cement, sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, lev elling as per RESPO cnstruction manual |
| 20 | Muffing of poles size 0.45x0.60 cm radius with 1:3:6(1 cement:3 coarse sand :graded stone 10 mm nominal size) block size 45 cm heigh t from ground level including cost of cement,stone and sand etc. |
| 21 | Dismantling of existing 11 KV Rabbit line. including disc fitting, Insulator, clamps, Nut & Bolts and consumer connections and Street light co nnections etc. including rolling of conductor and cartage back from site to JE store(ACSR Rabbit) |
| 22 | Cartage of ST pole SP-72 Poles from store centre to construction site with loading, unloading at both points and proper stacking.(Di stance 0-20 Km) |
| 23 | Cartage of other material (other than poles) by vehicle from Store Center to nearest construction site Store including loading and u nloading at both ends(distance 0-20 Km) |
| 24 | BACK CARTAGE OF PETTY MATERIAL, 0-20 KM |
| 25 | FIXING OF IPC WITH AL. BAIL FOR EARTHING |
| 26 | FIXING OF 11KV 90KN TENSION CLAMP B&IPC |
| 27 | FIXING OF 11KV IPC FOR CC TO CC COND. |
| 28 | FIXING OF 11KV IPC COVERED TO BARE COND. |
| 29 | SUPPLY & FIXING MID SPAN JOINTING SLEEVE |
| 30 | LAYING, SAGGING OF COVERED COND FOR 33KV |
| 31 | Erection/Fixing of 11 KV CABLE TIES FOR PIN INSULATOR Please Enable Macros to View BoQ information |
