|
| 1 | Excavation in post holes ( or similar holes ) each n,exe,0.50 cum getting out , returning , filling & ramming earth or broken rubble mixed with earth around in layers n. exc 25 cm.watering and removing surplus soil to a distance n,exe , 50 mtr in hard / dense soil complete all as specified. |
| 2 | M&L for PCC (1:3:6) type C2 using 40 mm graded stone aggregate as in foundation , filling & mass conc complete all as specified. |
| 3 | S & F Steel work in tubular trusses including special shaped washer etc. complete usingERW or induction butt welded tubes conforming to I. S.1161 1979 grade St.-240 complete all as specified. |
| 4 | S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified complete all as specified and as directed. |
| 5 | M&L preparation of new steel surfaces of Surfaces of any description, over 10cm in width or girth,not otherwise described and applying two coats of synthetic enamel paint over one coat of primer complete all as specified and as directed. |
| 6 | M&L for 100 mm thick PCC 1:4:8 type D-2 (40 mm graded crushed stone aggs) as in in sub base finish even and rough to receive to top layer complete all as specified. |
| 7 | S&F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts posts and struts in fencing including cutting tops to shape as directed, drilling holes,notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 |
| 8 | S&F mild steel screw bolts (machine made) or square heads at one end and screwed the other with length of bolt 50mm and diameter of shank 11 to 15 mm. |
| 9 | Material and labour for two coats of synthetic enameled paint on steel and iron surfaces over one coat of red oxide primer on surfaces n.exc. 10 cm width or girth including preparation of new surfaces complete all as specified & directed. |
| 10 | S&F Stainless steel wire cloth. 0.36mm nominal dia of wire and average width of aperture 1.40mm and fixed with stainless steel wire staples. |
| 11 | M&L Providing and laying 60mm thick factorymade chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks,lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & patternover and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of interlocking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified and as directed. |
| 12 | M&L Providing cement concrete 1:2:4 type B-1 using 20 mm graded aggregate as in kerbs or mud stops,rounded or chamfered on edges complete all as specified and as directed. Please Enable Macros to View BoQ information |
