|
| 1 | Supply, Installation, Testing & Commissioning of Indoor WiFi Acess point with specifications as follow: Chipset: Qualcomm; Mounting Ceiling / Wall; Antenna Type: Internal; Number Of Radios: 2; Frequency Band: Dual band; Supported Wi-fi Standards: 802.11a/b/g/n/ac; Max Wireless Signal Range im Mts: 50; Channel Width (MHz): 80 MHZ; Maximum Data Rate MBps: 1200; Supported Encryption: WEP/WPA2/AES; Receiver Sensitivity in db: -94; Transmit power (tx)(dBm): 27 dbm; Mode : AP / Router / Repeater / WISP: YES; Radio Resource Management such for power channel,coverage hole detection and performance optimization: Available; Support for Load Balancing between 2-4 Ghz and 5 Ghz (Via Controller ): Available; Support for Configurable Carrier; Threshold: Available; Device Management: Available;Support for MIMO ;Number of MIMO supported & Spatial Streams (Per band): 2X2:2;Number of WLAN (SSID) per AP: 8; Maximum clients Nos 128; Number of 10/100/1000 port: 2; Powering: DC + 802.3at PoE; Operating Temperature: Range (Degree C): 0 ~ 40 DEG CEL; Ingress Protection IP31; Modes Supported: AP + Repeater + Router. (Makes: Cisco/Allied Telysis/HPE/DLINK/Digisol) |
| 2 | Supply, Installation, Testing & Commissioning of WiFi Controller with specifications as follow: The wireless controller shall have Six RJ-45 auto-sensing 10/100/1000 ports ((IEEE 802.3 Type 10Base-T, IEEE 802.3u Type 100Base-TX, IEEE 802.3ab Type 1000Base-T); \\"The wireless controller should one fixed WAN ports & three convertable ports for load balancing; Two fixed LAN ports & three convertible ports; The device should have 1 console port (RJ-45/DB9); The device should support 1 USB for Keyboard / Mouse; Shall support IEEE 802.11b/g/n/ac Access Points for centralized management and control; The device should support DMZ function for server hosting applications; Shall support up to 512 AP's and 512 Users; The wireless controller shall be 1U 19\\" Rack-Mountable (the rack mounting kit shall be included); WLAN Controller Mobility Features; Shall support fast roaming providing service transparency and fast hand-offs across Access Points within and across subnet boundaries; Shall support QoS and security services which follow users as they roam; Shall have full service capabilities for wireless networks controlled across the WAN; Shall support central configuration of virtual service communities (or SSIDs) QoS, authentication, encryption, and VLANs; The proposed WLAN Architecture shall support distributed traffic forwarding allowing traffic to flow directly from source to destination, eliminating needless traffic to pass through the controller, delivering better performance and faster, more- responsive applications; Shall support distributed 802.1x authentication allowing controlled access points to directly authenticate users through an external RADIUS server without controller involvement; Shall support WAN failover over multiple WAN connection; Shall support Port forwarding for hosting virtual server; Shall support VPN or PPTP/L2TP; Shall support basic L3 routing features such as Static Routing; Shall support separate internal DHCP server can be configured for each LAN port to provide IP address to DHCP client devices; WLAN Controller Security Features; (Makes: Cisco/Allied Telysis/HPE/DLINK/Digisol) |
| 3 | Shall support authentication based on user credentials (802.1X/EAP), hardware identifiers (MAC address, WEP key), and HTML login; Shall support authentication and authorization through external RADIUS AAA services; Shall support built-in stateful firewall for secure connection to Internet; Shall support secure management interfaces, including access through CLI/Web; Shall support Access Control Lists based on IP address, protocol types and port filtering and URL filtering; Shall support VLAN mapping of guest access traffic for secure passage through corporate network; Shall have Captive portal for guest user authentication , MAC Authentication , PPPoe Authentication , Web Authentication for users; WLAN Controller Management & Other Features; Shall control a network of 512 Access points ensuring consistent security, QoS, and roaming services from AP to AP; Shall have scalability consistent in 802.11 a/b/g and 802.11n networks; Shall support auto AP discovery, monitoring and configuration throuh CAP/WAP protocol; Shall support central management of wireless access point operating modes; Shall support plug-and-play auto-discovery and software installation for easy access point deployment; Shall have easy-to-use web-based administrator interface; Shall support accurate seamless integration with wired network, leveraging existing L2/L3 infrastructure resources, e.g., QoS, VLANs, and External RADIUS AAA; Shall support RADIUS activity statistics collection per-user for billing by data volume and elapsed session time; AC can dynamically adjust uniform distribution of users among different AP using Policy Rules; Operating temperature up to 40°C etc complete as required.( Makes: Cisco/Allied Telysis/HPE/Digisol/Dlink) |
| 4 | Supply, Installation, Testing & Commissioning of 24 port PoE Switch with specifications as follow: Form Factor: Switch have 19\\" Rack Mountable (1U );Architecture: Non Blocking; Ports: 24 10/100/1000Base-TX ports with PoE + 2 gigabit Combo ports(RJ45/SFP) + 2 gigabit SFP ports; GBIC/SFP: support 2 gigabit combo ports (RJ45/SFP) + 2 x gigabit SFP Ports; Management Interface :Web/SNMP/SSH/Telnet(IPv6 ready)/Console; PoE: 270W (PoE+ supported) with (6Kv) surge protection; Port Status :Power, Link/Act, PoE; Power over Ethernet: Support IEEE802.3af, IEEE802.3at; 24 port PoE Interfaces, Max. PoE Wattage per Port: 30W; Surge Protection with 6 Kv surge protection per port; MAC Addresses: Supported Up to 8K MAC addresses; Switching capacity: 56 Gbps; Forwarding rate: 41.7 MPPS; VLANConfiguration: supports upto 4K VLAN Based on 802.1Q,MAC-Based VLAN, IP-Based VLAN; Protocol-Based VLAN. ( Makes: Cisco/Allied Telysis/HPE/Digisol/Dlink) |
| 5 | Supply, Installation, Testing & Commissioning of I/O Connector with specifications as follow: : Minimum 750 insertion cycles; Copper Alloy; Contact Force: 100g minimum; Plug Retention Force: 11 lbf minimum, UL listed, TIA/EIA-568-C, FCC etc complete as required.(Makes:- Molex/Commscope/Digisol/Dlink) |
| 6 | Supply, Installation, Testing & Commissioning of I/O Faceplate and back cover compatible with the above I/O Connector (Makes:- Molex/Commscope/Digisol/Dlink) |
| 7 | Supply, Installation, Testing & Commissioning of RJ-45 Connectors etc complete as required. (Makes:- Molex/Commscope/Digisol/Dlink) |
| 8 | Supplying and drawing of UTP 4-Pair CAT 6 LAN Cable suitable for high-speed data transmission up to 1 Gbps with a transmission frequency of 250 MHz or better, constructed with 23 AWG solid bare copper conductors, insulated with FR PVC outer jacket, in existing surface/recessed steel/PVC conduit including all necessary terminations, connections, dressing, and accessories as required to complete the work in all respects. (Makes:- Molex/Commscope/Dlink) |
| 9 | Supply, Installation, Testing & Commissioning of 20U System Rack with specifications as follow: Height: 20U; Width x Depth: 550mm * 500mm; Provisions: Front toughened glass with lock and key; Ventilation: Fan 90CFM 230V AC fitted on rack top; Wiring: 1U Cable Manger; Cable Manager: On top and bottom of Rack; Power Distribution: PDU 6 Point 5Amp Socket, Indian round pin with power Cable; Accessories: Mounting hardware packet of 10 piece.Valrack/Comrack/Netrack) |
| 10 | Supply, Installation, Testing & Commissioning of 9U System Rack with specifications as follow: Height: 9U; Width x Depth: 550mm * 500mm; Provisions: Front toughened glass with lock and key; Ventilation: Fan 90CFM 230V AC fitted on rack top; Wiring: 1U Cable Manger Metal with PVC Loop; Cable Manager: On top and bottom of Rack; Power Distribution: PDU 6 Point 5Amp Socket, Indian round pin with power Cable; Accessories: Mounting hardware packet of 10 piece. (Makes: Valrack/Comrack/Netrack) |
| 11 | Supplying, Installation, testing and commissioning of 24 Port Fully Loaded Jack panel with specifications as follow: 1U 24 Port Density; Each port features with spring-loaded shutter/ Dust Cover; IDC V-shaped contacts that flex not fatigue when terminated; Features pointed IDC towers to speed termination and enhance cable retention; Dual colour-coding allows for 568 A/B wiring configuration; Front and rear port labelling (port sequence 1–24) as well as panel identification label; 4 x 6 ganged jack configuration; Individually removable patch panel ports; Removable cable management shelf(s) ensure bend radius compliance; Available with either ANSI and metric hardware kit; Can be terminated using industry standard punch-down tools; RJ45 port which is RJ-11 compatible; Molded category identification on each port face as well as optional port identification icons; Flat type metal with Perforated Rear Cable Manager to hold CAT6 UTP Cable with velcro cable ties; RJ45 Jack should be supplied with Cap or Shutter to avoid Dust etc complete as required. (Makes: Molex/Digisol/Commscope/DLINK) |
| 12 | Supplying & Fixing of CAT-6 Patch cord of 3 meters length including Connecting Etc complete as required. (Makes: Molex/Digisol/Commscope) |
| 13 | Supply, Installation, Testing & Commissioning of 1KVA UPS with 15 Mins backup.( Makes: Microtek/Luminous/APC) |
| 14 | Supplying and fixing of 25mm size of heavy class FRLS PVC conduit having wall thickness 2.0mm along with accessories insurface/recess including painting in case of surface conduit, or cutting the walland making good the same in case of recessed conduit as required. (Makes: AKG/ Diplast/ BEC/ Anchor/ Polycab) |
| 15 | Supplying and fixing of DLP 20x12 mm PVC adaptable trunking on the existing wall at required height from lower level for networking connection, including partition chip, flexible cover, end cap, internal & external angle, tee, coupler, elbow and ther accessories as required complete in all respect .(Make:-AKG/ Anchor/ Polycab/ Precision) Please Enable Macros to View BoQ information |
