|
| 1 | Demolition of Reinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed. |
| 2 | M&L Reinforced cement concrete Nominal mix type B1 (using 20 mm graded crushed stone aggregate) as in slabs supported on walls , beams and columns in floors, roofs landings balconies, canopies, deck slabs and in shelves and the like complete all as specified and directed. |
| 3 | M& L for Formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including sup- ports, overhangs, etc. also splays between floors and beams, etc., flat rough finished surfaces of concrete complete all as specified and directed. |
| 4 | M&L Mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed. |
| 5 | M&L 75 mm thick cement concrete type D2 1:4:8 (using 40 mm graded crushed stone aggregate) as in pavings as specified and directed. |
| 6 | M&L Sand filling under floors or in foundations including watering and consolidation as sand cusioning complete all as specified and directed |
| 7 | M&L Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 80 mm thickness M-40 Grade with grey cement and pigment in hardstanding complete all as specified and directed |
| 8 | M&L preparation of new or previously untreated steel and iron surfaces of any description, over 10 cm in width or girth, not otherwise described and applying two coats of synthetic enemel paint over a coat of red oxide as specified and directed.. |
| 9 | Dismantling floor, hearth or wall tilling including cement mortar bedding (but not backing), removing servicieable tiles to store and rubbish off the premises. |
| 10 | Demolition of Concrete of any description and in any position not otherwise specifically provided for as specified and directed. |
| 11 | Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness (below or above ground floor) as specified and directed. |
| 12 | S&F light coloured non - skid Ceramic tiles 7 to 8 mm thick area of each tile exceeding 0.18 sqm but not exceeding 0.38 sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match, over and including 15 mm thick screed in cement mortar 1:6 all as specified and as directed |
| 13 | S&F coloured Glazed ceramic tiles in vertical surface 300x450x7mm thick set and jointed in neat cement slurry and pointed in white or colour cement to match over 10 mm thick rendering in CP 1:4 as specified and directed. |
| 14 | M&L for 75 mm thick, PCC 1:3:6 type C1 (using 20mm graded stone aggregate), finished even and and fair as in plinth protection incl joints filling complete all as specified. |
| 15 | M&L 20mm thick granite (of any type) work (table rubbed and polished) in steps, jambs,pillars, window cills, cooking platforms and like in cement mortar (1:4), 15mm thick including pointing in white cement (1:2) using marble dust with admixture of pigment to match with the granite complete all as specified and directed |
| 16 | Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc. laid bedded and pointed in any mortar incl removal of debries out side MD land. |
| 17 | M&L for complete removal of existing treatment of old treated surfaces of walls including washing, rubbing etc. and aapplying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm complete all as specified and directed. |
| 18 | Taking down shutter and refixing in the same opening, shutter. exc 1.sqm and n. exc. 2 sq. m each complete all as specified and directed. |
| 19 | Taking down chowkat or frames with shutter (without taking off shutters from the frame) not exc 1.5 sqm and removing from store complete all as specified and directed. |
| 20 | S&F solid PVC door frame of size 50mm x 47mm made out of 5mm plain colour PVC sheet, reinforced with MS square tube and fixing in position with hold fast, complete all as specified and directed. (Cost of hold fast included in the unit rate of this item.) |
| 21 | M &L factory made solid pannel PVC door shutter 30mm thick (style) consisting of frame made out of MS frame shall be covered with heat moulded plain colour PVC 'C' channel having a PVC sheet strip of 20 mm width stuck in side with solvent cement for stiles and plain colour PVC sheets for top rail, lock rail and bottom rail on either side & as gap insert for top rail and bottom rail panelling of plain colour PVC sheet to be fitted in the MS frame wedded /sealed to the styles and rails with suitable PVC sheet beading and joined together with solvent cement supplying and fixing in the frame at side,including two Nos tower bolts/ Handles for each shutter as per specification and drawing upto complete all as specified and as directed. |
| 22 | S&F light shade vitrified ceramic tiles 10 mm thick (square/rectangular) polished, area of each tiles not exceeding 0.36 sqm, in floor etc set and jointed in neat cement slurry and pointed in white or coloured cement to match, over and including 15 mm thick screed in cement mortar 1:6 all as specified and as directed |
| 23 | S&F light shade vitrified ceramic tiles 10 mm thick (square/rectangular) polished, area of each tiles not exceeding 0.36 sqm, in wall skirting etc set and jointed in neat cement slurry and pointed in white or coloured cement to match, over and including 10 mm thick plaster in cement mortar 1:4 all as specified and as directed |
| 24 | S&F Bands, straps, supports or stays for rainwater, ventilating pipes, including bolts, if required: hooks (stay), heavy, for large gates; hold fasts; wall ties; and similar small articles conforming to Fe-290 Gde-E-165 as specified and directed. |
| 25 | S&F 150 mm size extruded aluminium alloy handles fabricated type with plate anodized complete all as specified. |
| 26 | S&F 150 mm long aluminium anodized barrel tower bolts of extruded section complete all as specified. |
| 27 | S&F 150 mm long aluminium alloy anodised sliding door bolt with hasp staple (bolt type) and fixing clips of sheets cast or extruded sections or cast aluminium alloy complete all as specified. |
| 28 | M&L Machine cut polished sadarahalli stone slab flooring 20-25mm thick over cement screed base laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete |
| 29 | M& L for machine cut polished sadarahalli stone , uniform texture, in one p[iece in trade and risers, skirting of staircase incuding rounding the edge , cutting anti skid grooves 3 nos in each trade , plastering / screed 15 mm thick in CM 1:4 complete as specified and as directed. Please Enable Macros to View BoQ information |
| 30 | M& L for machine cut polished sadarahalli stone , uniform texture, in one p[iece in trade and risers, skirting of staircase incuding rounding the edge , cutting anti skid grooves 3 nos in each trade , plastering / screed 15 mm thick in CM 1:4 complete as specified and as directed. Please Enable Macros to View BoQ information |
