|
| 1 | Reinforced cement concrete work in walls (any thickness) including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts upto floor five level including curing but excluding cost of centering shuttering, finishing and reinforcement. 1:1.5:3 (1 cement : 1.5 coarse sand : 3graded stone aggregate 20 mm nominal size) |
| 2 | Reinforced cement concrete work in beams, suspended floors, roofs having slope upto 15°,landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases upto five level including curing but excluding the cost of centring, shuttering, finishing and reinforcement with 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size) |
| 3 | Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete above plinth level Thermo-Mechanically Treated bars of grade Fe-500D or more. |
| 4 | Providing & fixing upto floor five level precast cement concrete solid blocks including hoisting and setting in position in cement mortar 1:3 (1cement:3 coarse sand), cost of required centring, shuttering and curing complete - 1:3:6 (1 cement : 3 coarse sand : 6 graded crushed stone aggregate 20 mm nominal size) |
| 5 | 15mm thick cement plaster on the rough side of single or half brick wall of mix 13.2.1, 1:4(1 cement :4 fine sand ) including all carriage complete job. |
| 6 | Providing and fixing precoated galvanized iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. |
| 7 | Providing and fixing water closet squatting pan ( Indian type W.C. pan) with 100 mm sand cast Iron P or Strap, 10 litre low level P.V. C. flushing cistern including flush pipe (of approved make) \\"manually controled device (handle lever) conforming to IS:7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required. Orissa pattern white vitreous china W.C pan of size 580x440mm with integral type foot rests JAGUAR/CERA Make. |
| 8 | Providing and fixing white vitreous china pedestal type WC (European type/ wash down type) water closed pan. Etc. |
| 9 | White Vitreous china wash basin size 630x450 mm with a pair of 15mm C.P brass pillar taps ) water closet pan. |
| 10 | P/Fixing of mirrors of superior glass with plastic moulded frame (of approved quality) and of required size and shape. With 6mm thick hard board backing.Rectangular shape 1500x450mm complete. |
| 11 | Providing and fixing bore C.P Brass long body bib cock of approved quality conforming to IS standard and weighing not less than 690 gms. |
| 12 | Providing and fixing bore C.P Brass Angle cock of approved quality conforming to IS standards and weighing not less than 690gms. |
| 13 | Providing and fixing 3 layer Thermex Pipe PP-R (Poly propylene Random copolymer)pipes conforming to IS: 15801, UV stabilized and anti-microbial fusion welded, having thermal stability for hot and cold water supply including all PP-R plain and brass threaded Polypropylene random fittings. This includes testing of joints complete as per direction of Engineer-incharge.Internal work Concealed fixing the pipe with clamps at 1.00 meter spacing including cutting chases and making good the wall etc .(A) PN-16 Pipe,25mm OD (SDR-7.4) |
| 14 | PN-16 pipe , 32mm OD(SDR-7.4) |
| 15 | Supply and installation of High Quality self regulating heat tracer for Specialized Heating Solutions for Winterisation of water pipeline including all accessories complete including Supply and installation of Circuit Control Panel with RCBO MCB ,THERMOSTAT (0-120) DEG C, power connector-two way-6 sq.mm, w.p. splice connector,w.p. tee connector,end seal,mounting kit-w.p. jb,g.i. pipe strap 4\\",al. adhesive tape roll ( 50 mm w x 20 m l),f.g. adhesive tape roll (DANFOSS Make OR CHROMALOX any other approved brand as per the direction of Engineer-In-Charge) |
| 16 | Supply and installation of High Quality 32mm thick Nitrile Insulation Tube for water pipe line and rook wool of approved brand 2\\" size (Armaflex class-0 Armacell) including alumunium duct clading of approved quality and finish as per the direction of engineer in charge. |
| 17 | Providing and laying vitrified walls/ floor tiles in different sizes (thickness tobe specified by the manufacturer) with water absorption less than 0.08% and conforming to IS:15622 of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 (1cement :4 coarse sand) including grouting the joints with white cement and matching pigments etc. complete i.e Size of tile 600x600 mm |
| 18 | Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or dash fastener shall be paid for seperately) Kail wood. |
| 19 | Providing and fixing panelled and glazed shutters for doors, windows and clerestory windows, including ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws, excluding panelling which will be paid for seperately,all complete as per direction of Engineer-in-charge.(second class teak wood 30mm thick shutter) |
| 20 | Electrification (Ist and 2nd floor complete job) of the whole building by way of wiring for circuit/sub mains wiring along with wire of the following size FR moduler fitting with power plug wiring including PVC pipes casing wall fill. Socket 2 way pin change over MCB.With inveter line fitting with change over and batterry of 12 V and heating point complete job including PVC conduit in salb complete job. |
| 21 | Providing and and fixing traditionally carved wood work (Singstake) over doors and windows including all accessories as per the direction of the Engineer-in- charge complete with 32.6.1 2nd class kail wood. |
| 22 | Centering and shuttering including strutting, propping etc. and removal of form for: Coloumns, pillars,piers, abutment posts and struts etc. |
| 23 | Centering and shuttering including strutting, propping etc. and removal of form for: Lintels, beams ,plinth beams , girders, bressumers and cantilevers. |
| 24 | Centering and shuttering including strutting, propping etc. and removal of form for: Suspended floors, roofs, landings, balconies and access platform |
| 25 | Placing and fixing of 25mm dia 2mm thick ISI marked PVC conduit pipe for carrying electrical wiring in the slab with light box and fan box, including all sorts of carriage complete job. |
| 26 | Structural steel Trusses work in built up sections, trusses and framed work in built up sections, trusses and framed work, including cutting, hoisting , fixing in position and applying a priming coat of approved steel primer all complete 10.2.2 Welded including carriage complete. |
| 27 | Providing and fixing wooden stair reiling including all necessary items complete job |
| 28 | Providing and fixing 12mm thick wooden ply including all necessary items complete job. |
| 29 | Providing and fixing 2000ltr syntex including insulation with alumuinium sheets (Winter Friendly) complete job. |
| 30 | Float glass pane 4mm thick glass pan (weighing not less than 10kg/sqm) including wooden pedaing including all sorts of carriage complete. |
| 31 | Varnishing with varnish of approved brand and manufacture in Doors/windoors paniling/shingtsak all wooden items complete job |
| 32 | Providing and fixing 2nd class teak wood plain lining tongued and grooved including wooden pluges complete with necessary screws and priming coat on unexposed surface 12mm thick. |
| 33 | Providing and applying plaster of paris putty of 2mm thick ness over plastered surface to prepare the surface even and smooth complete. |
| 34 | Finishing walls with Deluxe Multi surface paint system for interiors and exterior susing primer as per manufactires specification :Two or more coats applied on walls @1.25 ltr/ 10 sqm over and including one coat of special primer applied @ 0.75 ltr/10 sqm. Please Enable Macros to View BoQ information |
