|
| 1 | \\"Site Clerance including labour and matrialsand including grass cutting /Dressing andcarrage of matrials by Head load\\" |
| 2 | Dismenteling of old damadged interlocking tiles with all complete NSI |
| 3 | \\"E/W filling in embankment with cartage soilup to 8.00 km distances etc com.\\" |
| 4 | \\"Dismenteling of Brick Work includingStacking of materials as directed by theEngineer-in-Charge with the distance of60.00m. Work SI No. 692\\" |
| 5 | \\"E/W in Excavation in ordenery soil infoudation including labour and matrialsand T/P with all com. Work SI No. 251\\" |
| 6 | \\"C.C. Work in 1:6:12 in cement, fine sandand 40 mm Gauge Brick Ballast includinglabour and matrials , T/P with all com.Work SI No. 273\\" |
| 7 | \\"M-150 B/W in 1:4 in cement and coar sandmortar including labour and matrials , T/Pwith all com. Work SI No.305\\"DEDUCTED TO BRICKS AND BATS RS 12575.00 |
| 8 | \\"12 mm thick plaster work in 1:3 with cement and fine sand etc all complete.S.I.No 584\\" |
| 9 | \\"R.C.C. Work in 1:1.5:3 in cement coarsesand and 20mm gauge including labourand matrials, T/P with all com. Work SINo.285\\" |
| 10 | \\"MS work in R.C.C. work includinglabour and matrials , T/P with all com.Work SI No.504\\" |
| 11 | \\"Construction of Granular sub base (GSB) byproviding coarse graded material spreadingin uniform layers with motor grader onprepared surface, mixing by mix in placemethod with rotavator at OMC, andcompacting with vibratory roller to achievethe desired density, complete as per Clause401 ..\\" |
| 12 | \\"P /L of 80 mm thick rubber mouldednterlocking cement concrete Paverblocks,Work SI No. 786(I)\\" |
| 13 | Relaying of old interlocking paver blockwith all comp. |
| 14 | For colourd Interlocking |
| 15 | P.C.C work in 1:2:4 with cement and c/sand including etc all complete. |
| 16 | \\"Supply and fixing of Stone patiya of 75mmto 80mm Thick for Covered the nala/naliincluding all complete.Size (0.45 x 0.60 x 0.08\\" |
| 17 | S/F Precasted cement concrete bench with allcomp work.(market rate) |
| 18 | S/F of submersible pump with motormatrials T/P with all com. Work. |
| 19 | Providing and fixing Pre-laminated flatpressed 3 layer (medium density)particle board or graded wood particleboard IS : 3087 marked, with oneside decorative and other side balancinglamination Grade 1, Type IIexterior grade IS : 12823 marked, in |
| 20 | S/F of 12.50 meter high mast shaft ofapproved make with rising system hotdip galvanised inside & out side deephaving pole sheet thickness 3mm.Topminimum 150mm ,bottom dia 310mmbase plate 25mm thick suitable forwindwind velocity completerespect .PWD SI No-651 |
| 21 | Supply and fixing of factory wired integralLEDflood light luminaires with die castaluminiumhousing built with dirver set suitable for 170to 200Watt. Confirming to IPcomplete in all |
| 22 | Supply and Burying or safe earthingelectrode T-39(Hot Dip Galvanised)length up to 3000mm,outer pipe 76mminner 38 mm complete in all respect.PWD SI No-725(D) |
| 23 | Supply and Laying of 63 mm HDPE Pipeblack for the protection of cable. |
| 24 | Supply and Laying of alluminium conductorPVC insulated armored served sheathedcables 1100 volts grade size 16 Sqmm 4 coreat adepth of 750mm below ground level overa cushion of 75mm thick sand all around andprotected with burnt brick on sides sand ontop. one surface the cable run shall be fixed ofM.S. clamps etc.of suitable sizers as directedby the Engineer in charge. complete in allrespect the armouring of the cable shall beproperly connected with the earth conductedwith the earth conductor by clamps etc.(PWD S.I. No. 501) (i) |
| 25 | Supply and Wiring of sub main with of3core 6 Sqmm P.V.C insulated single corecopper conducter cable with conduit pipeincluding in all comp.501(1) |
| 26 | Twin Aviation light(Reputed/BrandMake) |
| 27 | Supply and erection of factory fabricatedand wired metal clad dust and verminproof floor mounting panel TPN switchboard complete with the following HRCtype heavy duty TPN fuse switches withfuses and instrument chamber etc.complete in separate and shall compriseof flush type ammetervoltmeter,instrument fuses,current |
| 28 | \\"Shifting of all material ,add to item 251-253for every additional 30m .lead or part of30m.or for every additional 1.50m lift orpart of 1.50m .Work SI No-254.250 m distance\\" |
| 29 | Add 18% GST Please Enable Macros to View BoQ information |
