Tender For Making 2 No.S Of Temporary Pumping Shed At Main Sump And Coal Face Near At Parsodikala Patch At Amera Ocp Of Bishrampur Area .(For Monsoon Preparation), Bishrampur-Chhattisgarh
TDR : 54873412
Tender Notice
BOQ
11 Days Left
Bishrampur
Chhattisgarh
Tender For Making 2 No.S Of Temporary Pumping Shed At Main Sump And Coal Face Near At Parsodikala Patch At Amera Ocp Of Bishrampur Area .(For Monsoon Preparation)
Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil.
2
Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size).
3
Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:2:4 (1 Cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size).
4
Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry, but excluding the cost of nosing of steps etc. complete. 40 mm thick with 20 mm nominal size stone aggregate.
5
Structural steel work in single section fixed with or without connecting plate including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.
6
Painting with synthetic enamel paint of approved brand and manufacture to give an even shade : Two or more coats on new work.
7
P/F pre coated galvanised iron profile sheets 0.50mm (+0.05%) total coated thickness with zinc coating 120gms per sqm as per IS:277 in 240 mps steel grade, 5-7 microns epoxy primer on both sides of sheet and polyster top coat 15-18 microns. Sheet should have protective gaurd film of 25 micron minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by E-I-C. The sheet shall be fixed using self drilling /self tapping screws of sizes (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal /vertical or curved surfaces excluding the cost of purlins,rafters and trusses and including cutting of size and shape wherever required.
8
Total impact of GST for the purpose of CTC Please Enable Macros to View BoQ information
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
