PROVDING WATER PROOF SHEEDS AT GEN SETS INSTALLED IN POLICE LINES, SECTOR-26, CHANDIGARH
Date
01-04-2026
Name of Work:- PROVDING WATER PROOF SHEEDS AT GEN SETS INSTALLED IN POLICE LINES, SECTOR-26, CHANDIGARH
Sl. No.
Item Description
1
Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), includingdressing of sides and ramming of bottoms, for all lift, including getting out the excavated soiland disposal of surplus excavated soil as directed, within a lead of 50 m. (D.S.R-2.8.1)
2
1:5:10 (1 cement : 5 coarse sand (zone-III) derived from natural sources : 10 graded stoneaggregate 40 mm nominal size derived from natural sources)
3
Providing and laying in position specified grade of reinforced cement concrete, excluding thecost of centering, shuttering, finishing and reinforcement - All work up to plinth level :1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources : 3 graded stoneaggregate 20 mm nominal size derived from natural sources)
4
Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works
5
Providing corrugated G.S. sheet roofing including vertical/ curved surfacefixed with polymer coated J or L hooks, bolts and nuts 8 mm diameterwith bitumen and G.I. limpet washers or with G.I. limpet washers filledwith white lead, including a coat of approved steel primer and two coatsof approved paint on overlapping of sheets complete (up to any pitchin horizontal/ vertical or curved surfaces), excluding the cost of purlins,rafters and trusses and including cutting to size and shape whereverrequired. 0.63 mm thick with zinc coating not less than 275 gm/ m2
6
Providing and fixing IRC welded steel wire fabric of size 3\\" x 1\\" wire of 12 gauge in existing angle iron frame properly welded to the frame with the help of existing MS flat 25x5mm beading by cutting to the required size, straightening in position complete in all respect to the entire satisfaction of Engineer-in-charge. Please Enable Macros to View BoQ information
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
