|
| 1 | Stripping off worn out plaster and raking out joints of walls,celings etc. upto any height and in any floor including removing rubbish within alead of75m as directed. |
| 2 | Supplying, fitting and fixing M.S. clamps for door and window frame made of flatbent bar, end bifurcated with necessary screws etc. by cement concrete (1:2:4) as per direction. (Cost of concrete will be paid separately) (a) 40mm X 6mm, 250mm Length |
| 3 | Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark. (i) 50mm. X 37mm. X 1.50mm. |
| 4 | 125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in ground floor |
| 5 | Neat cement punning about 1.5mm thick in wall, dado, window sill, floor etc. NOTE:Cement 0.152 cu.m per100 sq.m. |
| 6 | Plaster (to wall, floor, ceiling etc.) with sand and cement mortarincluding rounding off or chamfering corners as directed andraking out joints including throating, nosing and drip course,scaffolding/staging where necessary (Ground floor).[Excludingcost of chipping over concrete surface] |
| 7 | Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame exluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be correted upto three decimals).(c)Sal:Siliguri. |
| 8 | Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings.(iv) 25mm thick shutters with 12mm thick panel of size 30 to 45 cm.(b) Sishu, Gamar, Champ, Badam, Bhola, Mogra, Hallak. |
| 9 | (b) Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. |
| 10 | (A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : (a) On timber or plastered surface : With hi- gloss of approved quality(ii) Two coats (with any shade except white) |
| 11 | (A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand parpering etc. including using of approved putty etc. on the surface, if necessary.(b) On steel or other metal surface:With super gloss (hi-gloss),i) One coats (with any shade except white) |
| 12 | Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc. A) Floor With Sand Cement Mortar (1:4) 20 mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m & joint filling using white cement slurry @ 0.20kg/Sq.m. a) Area of each tile upto 0.09 Sq.m (ii) Other than Coloured decorative including white |
| 13 | Providing and fixing 30mm thick factory made solid PUF (Poly Urethene Foam core solid PVC shutter shall consists of periferial frame made out of 19mmX19mm 19gauge MS Tube. The core panel shall consist of 20 mm thick high density of PUF conforming to IS:12436-1988.5mm thick PVC sheet to be fixed on both face of the MS frame. The door on all the edge to be sealed with lipping of 10mm(5x2mm) thick x 20mm wide PVC sheet by using solvent cement. 20mm th. partcle board should be Inserted for locking arrangement. a) Single pices extruded Puf insulated door shutter, Matt/Plain finish |
| 14 | Supplying, fitting and fixing pillar cock of approved make.(a) (i) Chromium plated Bib Cock short body (Equivalent to Code No. 511 & Model - Tropical / Sumthing Special of ESSCO or similar brand). |
| 15 | Supplying, fitting and fixing Anglo-Indian W.C. in white glazed vitreous china ware of approved make complete in position with necessary bolts,nuts etc. (a) With 'P' trap (with vent) |
| 16 | Supplying, fittingand fixingwhitevitreous chinabest qualityapproved makewashbasinwithC.I. bracketson75mmX75mmwoodenblocks, C.P.wastefittingsof32mmdia.,oneapprovedqualitybrassC.P.pillar cockof15mmdia.,C.P.chainwithrubberplugof30mmdia.,approved qualityP.V.C.wastepipewithC.P.nut32mmdia.,900mmlongapproved quality P.V.C. connection pipe with heavy brass C.P. nut including mendinggoodall damagesandpainting thebracketswith twocoatsof approved paint. (ii) 550 mm X 400 mm size |
| 17 | Providing and fixing concealed cistern of size 380 mm long, 400 mm wide, 100 mm thick along with flush plate and flush pipe with minimum distances of 37 mm from wall face with concealed fittings arrangement of approved quality with all fittings and fixtures complete, including cutting and making good the walls wherever required. (Model: Cento of Hindware or similar brand.) |
| 18 | Dismantling all types of plain cement concrete works, stacking serviceable materials at site and removing rubbish as directed within a lead of 75 m.In ground floor including roof. (a) upto 150 mm. thick |
| 19 | Supplying, fitting and fixing CPVC (Chlorinated Polyvinyl Chloride) pipes of approved make conforming to IS-15778: 2007 . with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. (a) For Exposed Work (i) CPVC Pipes Class-1, SDR-11 (Dia) 15 mm |
| 20 | Purchasing of a Water Purifier (RO) machine. ….. as per the instruction of E-I-C. |
| 21 | Minor internal electrification work …... as per the instruction of E-I-C. |
| 22 | Un-skilled labour …... as per the instruction of E-I-C. |
| 23 | Adding GST @ 18% |
| 24 | Adding L.W. Cess @ 1% Please Enable Macros to View BoQ information |
