|
| 1 | NOTE: Schedule ‘A’ Part - ItoPart -XIVare Prepriced by MES. Bidders shall insert their lumpsum amount in the Green coloured field under Col-6 only. |
| 2 | Total amount of Sch \"A\" Part - I(BUILDING Works) |
| 3 | Total amount of Sch \"A\" Part - II(DEMOLITION OF BLDG) |
| 4 | Total amount of Sch \"A\" Part - III (SITE CLEARANCE & EART WORKS) |
| 5 | Total amount of Sch ‘A’ Part - IV (INTERNAL ELEC SUPPLY) |
| 6 | Total amount of Sch ‘A’ Part - V(ROAD,PQC,PATH,HARD STANDING ABD CULVERT WORKS) |
| 7 | Total amount of Sch ‘A’ Part - VI (PRPTECTIVE WORKS) |
| 8 | Total amount of Sch ‘A’ Part - VII(AREA DRAINAGE) |
| 9 | Total amount of Sch ‘A’ Part - VIII (LIGHTENING PROTECTION) |
| 10 | Total amount of Sch ‘A’ Part - IX (BLAST WALL) |
| 11 | Total amount of Sch ‘A’ Part - X (ANTI FLOOD BUND) |
| 12 | Total amount of Sch ‘A’ Part - XI ( EXTRNAL WATER SUPPLY WORKS) |
| 13 | Total amount of Sch ‘A’ Part - XII (EXTERNALELECTRIC SUPPLY WORKS) |
| 14 | SCH \"A PART - XIII(Miscellaneous B/R and E/M works for Sch \"A\" Part-II to Part-XVI)Note: This schedule is not pre-priced by MES and the rate indicated as \"Rs 0.00\" under Col 5 signifies this fact only |
| 15 | S & F Factory made Flame proof sheet metal enclosure for mounting MCBs with 200 Amp rated bus bar SPN 12 way AC 240 volts , IP-65 protection complete all as specified and directed. |
| 16 | M & L forpolyethene film, black 125 micron laid in floor over sand cushioning for laying pavement quality concrete, complete all as specified and directed. |
| 17 | Supply and Fixing for octagonal pole 12 mtr longflanged type (6 mtr each pole)for hanging of Al wire and fixing of air termination rod all as specified and as directed. |
| 18 | Supply and fixing nitryle rubber insulation for tubing of size suitable for any pipe size & 32mm-50 mm thick outer dia, conductivity suitable for temperature range of (-)40ºC to (+)40ºC and class-0 fire resistance, water vapour permeability > 7000 and CFC free complete all as specified and directed. Note:-Area will be calculated based on outer dia complete all as specified and directed. |
| 19 | Providing and fixing of aluminium cladding of 0.32 mm thick Aluminium Sheet on insulated pipes40 mm dia pipe (for exposed pipes only) complete all as specified and directed. |
| 20 | Supply installation testing and commisiioning of open well submersible pump with control panel of capacity 1 HP ,head 07 to 40 mtr complete all as specified and directed. |
| 21 | Supply and fixing junction box made out of 3.15 mm thick MS sheet powdered coated with locking arrangment of size (30 cm x 15 cm x 8 cm) including 01 No 6 Amp SP MCB, 2 Nos bus bar of suitable size with suitable number of holes fixed on Street light pole with suitable MS clamps complete all as specified and directed. |
| 22 | Supply ,Install Testing & Commissioning ofself supportingtotally enclosed double door at front, LT feeder piller compartmentalised design, dust and varmin proof of size 600 mm(Height) x 600 mm(Length) x 450 mm(Width)suitable for 440 Volt 3 phase 4 wire system made out of 3.15 mm thick CRCA sheet and built upon regid frame work having front and rear hinged doors with neoprence rubber gasket including danger plate, earthing strip point and, ventilation louvers at the rear side, bottom detachable gland plate complete with suitable size of Zinc/Cromium plated and nuts, bolts ;and washers etc. The pannel shall be synthetic enamelled paintedand the control circuit diagram shall bewith colour code solid conductorcopper 1.5 sqmm cable for easy identification including incomming/outgoing cable holes at the bottom, complete after taking down the old unserviceable one.The Panelshall be emmbeded with 75 x 6 mm MS Angle Iron frame and to be grouted with PCC foundation (1:2:4 )type B2 upto a height of 50 cm from normal ground level complete all as specified and directed by Engr in charge and comprising of the following. |
| 23 | (a) Aluminium bus bar 100 amps - 04 Nos, supported with suitable size of heavy duty porcelin stand lock with suitable sizeof brass nut, bolts and washer with heat shrinkable PVC sleeving.The bar shall be colour coded (red, yellow and blue) for three phases and black for neutral.(b)MCB of SPN, 63 A, 10 KA, with breaking capacity of 25 KA, - 01 No(c)MCB of SP, 06 to 32 A, 10 KA, - 02 No(d)MCB SP 10A , A0 KA -02 NosINDICATING DEVICES(a) LED Indicating lamps for Main Supplyindicating R\", Y\" B\"- 01 Set of 3(b) Digital Voltmeter- 01 No(c)Current Transformer havingRatio 400/5, 15 VA- 01 Set of 3(d) Digital Ammeter- 01 N0 |
