|
| 1 | NOTE: Schedule ‘A’ Part - ItoPart -IXare Prepriced by MES. Bidders shall insert their lumpsum amount in the Green coloured field under Col-6 |
| 2 | Total amount of Sch \"A\" Part - I (BUILDING WORKS) |
| 3 | Total amount of Sch \"A\" Part - II(SITE CLEARANCE/ AREA DEVELOPMENT/ EXCAVATION AND EARTHWORK) |
| 4 | Total amount of Sch ‘A’ Part - III (INTERNAL ELECTRIFICATION WORKS) |
| 5 | Total amount of Sch ‘A’ Part - IV (INTERNAL WATER SUPPLY) |
| 6 | Total amount of Sch ‘A’ Part - V (SEWAGE DISPOSAL) |
| 7 | Total amount of Sch ‘A’ Part - VI (ROAD/ PATH) |
| 8 | Total amount of Sch ‘A’ Part - VII (EXTERNAL WATER SUPPLY) |
| 9 | Total amount of Sch ‘A’ Part - VIII (EXTERNAL ELECTRIFICATION WORKS) |
| 10 | Total amount of Sch ‘A’ Part - IX (HOT WATER SUPPLY) |
| 11 | SCH \"A PART - X(Miscellaneous B/R and E/M works for Sch \"A\" Part-II to Part-IX)Note: This schedule is not pre-priced by MES and the rate indicated as \"Rs 0.00\" under Col 5 signifies this fact only |
| 12 | Point wiring with 1.5 Sqmm (nominal area) copper conductor FRLS cable (multi-stranded) PVC insulated and sheathed electric cable 1100 volts drawn through and including PVC Conduit of suitable size (as per conductor run) with all fittings and accessories and including PVC insulated unsheathed electric cable 1100 volts 1.5 Sqmm (multi-stranded) copper conductor single core (green colour) as continuous earth wire connected to common earth dolly including MS/ GI sunken boxes covered with 3mm thick plastic laminated sheet ISI marked for following complete :- |
| 13 | One light/fan point controlled by one 5 Amps one way switch |
| 14 | One 3 pin socket outlet 5 Amps on independent board |
| 15 | One 3 pin socket outlet 5 Amps on same board |
| 16 | Point wiring for power point with 2.5 sqmm (nominal area) copper conductor FRLS cable ( multi-stranded) PVC insulated and sheathed cable conductor 1100 Volts drawn through and including PVC Conduit of suitable size (as per conductor run)with all fittings and accessories and including PVC insulated unsheathed electric cable 1100 volts 2.5 Sqmm copper conductor single core (green colour) as continuous earth wire connected to common earth dolly including MS/ GI sunken boxes covered with 3mm thick plastic laminated sheet ISI marked complete.Note for Srl Item No 12 & 13 here-in-before : (i) The rates quoted against these items shall be inclusive of cutting chases, pinning in for concealed conduit wiring, making good the surfaces using Cement Mortar 1:3, cutting exceeding 10 cm but not exceeding 20cm girth.(ii) Screw used for conduits, ceiling roses, sunken boxes, for fixing plastic laminated sheet etc. shall be of Nickel/ Cadmium. |
| 17 | Flame proof Point wiring with two single core FRLS-H PVC insulatedmulti stranded copper conductor of size 1.5 sqmm, 1100 volts grade drawn through and including PVC Conduit of suitable size (as per conductor run) with all fittings and accessories and including FRLS-H PVC insulatedmulti stranded copper conductor of size 1.5 sqmm single core (green colour) as continuous earth wire connected to common earth dolly including MS/ GI sunken boxes covered with 3mm thick plastic laminated sheet ISI marked complete.Note for Srl Item No 12 & 13 here-in-before : (i) The rates quoted against these items shall be inclusive of cutting chases, pinning in for concealed conduit wiring, making good the surfaces using Cement Mortar 1:3, cutting exceeding 10 cm but not exceeding 20cm girth.(ii) Screw used for conduits, ceiling roses, sunken boxes, for fixing plastic laminated sheet etc. shall be of Nickel/ Cadmium. |
| 18 | Sub main wiring for circuit/ submain wiring along with earth wire FRLSH PVC insulated copper conductor of size 2 x 10.00 sqmmand 1 x 10.00 sqmm earth wire single core cabledrawn through and including PVC concealed conduit complete. |
| 19 | Sub main wiring for circuit/ submain wiring along with earth wire FRLSH PVC insulated copper conductor of size 2x6.0 sqmmand 1 x 6.0 sq. mm earth wire single core cabledrawn through including PVC concealed conduit complete. |
| 20 | Rechargeable LEDBulb 9 W, 220 V, white color all as specified and as directed. |
| 21 | GIPipe (medium grade, ISI Marked) 32 mm dia ,1.5 mtr long ,bend to shape for street light fitting bracket ,with 2x pairs of MS clamps of suitable length of size 40x5 mm of MS flat iron with nuts bolts and washer and taking out old one including connection with street light complete all asdirected. |
| 22 | 40W Tube insect catcher electric insect killer indoor type (fly swatter) with complete connection complete all asspecified and directed. |
| 23 | Duct type chimney with inbuilt exhaust fan of capacity 200 Watt with minimum airflow 400 cum/hr, from opening top of kitchen platform opening 1.5m x .6m with all insulation and fitting complete all asspecified and directed. |
| 24 | M&L for Elestometric Nytral rubber insulation to PP-R pipes suitable for 20mm outer dia 22/19mm thick with chiken wire mesh wire netting 25mm gauge, 20mm mesh with including 0.5mm thick aluminium sheet cladding including jointing and fixing material such as solvent adhesive SR-998 complete all as specified and directed by Engr-in-Charge. |
| 25 | All as per Srl item No 21 above, but of size 25 mm dia. |
| 26 | S&F Puff Water Tank 500 liters capacity, insulated vertical type double layer duly filled with glass wool hoisted and to resist in temperature -30 degree to +35 degree Celsius fixed in position with all fittings complete all as specified and directed. |
| 27 | Supply, Installation, testing & commissioning ofself supportingtotally enclosed double door at front, LT feeder pillar box compartmentalized design, dust and varmin proof of size 600 mm(Height) x 600 mm(Length) x 450 mm(Width)suitable for 440 Volt 3 phase 4 wire system made out of 3.15 mm thick CRCA sheet and built upon rigid frame work having front and rear hinged doors with neoprene rubber gasket including danger plate, earthing strip point and, ventilation louvers at the rear side, bottom detachable gland plate complete with suitable size of Zinc/Chromium plated and nuts, bolts ;and washers etc. The panel shall be synthetic enamelled paintedand the control circuit diagram shall bewith colour code solid conductorcopper 1.5 sqmm cable for easy identification including incoming/outgoing cable holes at the bottom, complete after taking down the old unserviceable one.The Panelshall be emmbeded with 75 x 6 mm MS Angle Iron frame and to be grouted with PCC foundation (1:2:4 )type B2 upto a height of 50 cm from normal ground level complete all as specified and directed by Engr in charge and comprising of the following. |
| 28 | (a) Aluminium bus bar 200 amps - 04 Nos, supported with suitable size of heavy duty porcelin stand lock with suitable sizeof brass nut, bolts and washer with heat shrinkable PVC sleeving.The bar shall be colour coded (red, yellow and blue) for three phases and black for neutral.(b) MCCB TPN , 63 A, 10 KA, with breaking capacity of 25 KA, Make : L & T/Havells - 01 No.(c) MCB of SPN 40 Amps, 10 KA,Make : L & T/Havells - 05 Nos.(d) LED Indicating lamps for Main Supplyindicating R\", Y\" B\"- 01 Set of 3. (e) Digital Voltmeter (Make AE/L&T) - 01 No.(f) Current Transformer havingRatio 200/5, 15 VA- 01 Set of three.(g) Digital Ammeter ( Make(AE/L&T) - 01 No. |
| 29 | Supply, installation, testing and commissioning of ‘Solar Hot water system’ (Flat Plate Collector) based on indirect transfer of heat of capacity 500 LPD including backup stainless steel hot water tank duly insulated and provision of heating element with thermostat complete all as specified and directed”.Note : The unit rates quoted against this item shall be inclusive ofbackup stainless steel hot water tank duly insulated |
| 30 | Supply and fix Stand Alone Heater with heating capacity of25000 Kcal/Hr with 2 HP blower motor and complete accessories:-(a) No of Passes - 04 Passes, (b) Hot Air Temp- 80 Degree C, (c) Process Air Flow at STP (1.2 Kg/m3 air density)- 80 Degree C, (d) Thermal Efficiency - 90%(e) Fuel Type - Diesel/Kerosene, (f) Max Fuel Consumption (HSD) - 1.2 kg/hr (on full load however fuel consumption will vary depending on process temperature and air requirement)(g) Electricity Supply - 415±6%, 50Hz±3%, 3 Phase, 4 wire, (h) Fuel filter and tank - Provided, 10 Ltr(j) Burner - burner fitted with imported(k) Blower Fan - Double inlet backward curved centrifugal fan suitable for high pressure upto 80mmwc(l)Blower Motor -FHP, Standard make (ABB/Siemens/Equivalent) for up to 25000 Kcal/hrs size(m) Drive - Belt driven through taper lock pulleys and belt to adjust RPM as per process air flow and pressure requirements, (n) Temperature Control - Automatic through digital temperature controller(o) Control Panel- Pre-wired powder coated control panel with user friendly audio-visual controls, safeties, interlocks, MCB, overload relays, timers and alarm hooter(p) Blower fan guard, (q) Outer Body - Fabricated out of mild steel duly insulated from inside and 1 Mtr exhaust pipe of aluminium sheet 1.6 mm.Make: Alfatherm/Jevica/Equivalent |
