|
| 1 | SCHEDULE ‘A’ Part - I (Repair Work ) |
| 2 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth 1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources : 6 graded stone aggregate 20 mm nominal size derived from natural sources) |
| 3 | Brick work withcommon burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement : 6 coarse sand) mix |
| 4 | 20 mm cement plaster on rough side of single or half brick wall of mix 1:6 (1 cement: 6 coarse sand).(External surfaces of wall). |
| 5 | Supply and laying Dry brick pitching half brick thick with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in floor sub base drains including preparing the surface complete. |
| 6 | Supply, fixing Steel work in built up tubular (round, square or rectangular hollow tubesetc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete, Hot finished welded type tubes. |
| 7 | Providing and fixing Kiln seasoned and chemically treated hollock wood frame work consisting of battens 50x25mm fixed with rawl plug and drilling necessary holes for rawl plug etc. including priming coat completeand as per direction of Engr - in - Charge. |
| 8 | Providing and fixing 25 mm thick 2nd class teak wood plain lining tongued and grooved, including wooden plugs complete with necessary screws and priming coat on unexposed surface. |
| 9 | French spirit polishing Two or more coats on new works including a coat of wood filler. |
| 10 | Providing wood work in frames of doors and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia & length (hold fast lugs or dash fastener shall be paid for separately) with Second class teak wood. |
| 11 | Providing and fixing 35 mm thick panelled shutters for doors, fixing with butt hinges of required size with necessary screws, excluding panelling which will be paid forseparately, all complete as per direction of Engineer-in-charge with Second class teak wood. |
| 12 | Providing and fixing Second class teak wood panelling for doors (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick. |
| 13 | Providing and fixing 250x10 mm size bright finished brass tower bolts (barrel type) withnecessary screws etc. complete |
| 14 | Providing and fixing 125mm size bright finished brass handles with screws etc. complete |
