Tender For Anganwadi Center Building Repair Work, Karauli-Rajasthan

Tender For Anganwadi center building Repair Work-1. Break the beams above the RCC roof and collect the broken material on the ground floor. 2. Break the cement concrete floor and throw the broken material up to a distance of 50 meters. 3. Break the old plaster (lime or cement), scrape the joints, and clean the surface. Net 4. Masonry of first-grade bricks in a cement-gravel mortar of 1:6, including sealing the side gaps and leveling. 5. Supplying chiseled stone niches and supports and applying them in a cement mortar of 1:3. 6. Mix 40 mm of stone aggregate/brick aggregate in a cement-sand mortar ratio of 1 cement to 6 sand to 12 gravel in the cement concrete foundation or floor and ramming, including leveling. 7 Supplying white glazed china clay tiles and applying cement slurry over plaster and filling joints with white cement (plasters price not included). 8 Cement plastering of walls using a 1:6 cement-gravel mixture, including scouring and leveling of joints. 20 m.g. Net 9 Distempering work on all new work On new work as PWD BSR 10 Applying enamel paint to create an even surface on new work/old work. On new work 11 Supplying stone door and window frames and applying cement mortar 14 Analysis of a single 100 x 75 mm sheet for a 4 meter door frame. Supply and installation of a 22 gauge plain GI sheet door with a 40x40x3 mm angle iron frame, along with fittings like sliding bolts, latches, and locking strips, etc., in a 25x25x3 mm angle iron frame. GI plain sheet analysis for a 1x2 sq. meter door. A window made of 22 gauge plain GI sheet, including the entire frame and frame of 25x25x3 mm angle iron, with a 10 mm grill with angles, two latches, and one strip. Supply and installation of a 14 to 24 gauge iron mesh in a GI plain sheet iron window, and screwing it with a 2003 mm weld. Cement concrete screed (1 part cement: 3 parts gravel: 6 parts 12 mm aggregate) of 90 mm average thickness should be laid, including tamping and compaction. (i) The screed should be laid in such a way that a slope of 1:50 is obtained in the desired direction and as per the specifications, 6 mm diameter rods should be placed at 25 cm centre to centre in both directions, including concrete in the centre. (ii) In case of trenching less than the prescribed thickness, 10% of the total cost should be deducted for every inch less thickness.

Refer document

INR 1.98 Lakhs /-

FileName	File Description	File Size
Click here to download tender document	Tender Documents	0 KB