|
| 1 | Repair and Renovation works in Board room\"s Visitors waiting hall in Technical office building at FACT CD,Ambalamedu,Kochi. |
| 2 | Chipping & removing old cement plastered surface including racking out joints & clearing the surface for replastering & disposal of the debris as per directions within a distance of 150 m. |
| 3 | Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in charge.In cement mortar. |
| 4 | Chipping and removing mosaic flooring/ Wall /Floor tiles/ skirting in the halls and other areas very carefully without damaging the remaining portions and water supply items and removing the debris to places pointed out by the department. |
| 5 | Dismantling existing old sanittary fittings like wash basin, EWC, Urinal etc and removing all internal water lines and waste lines carefully without damaging the building as instructed at site from 2 toilet blocks. |
| 6 | Dismantling doors, windows and clerestory windows (steel or wood)shutter including chowkhats, architrave, holdfasts etc. complete andstacking within 50 metres lead :Of area beyond 3 sq. metres |
| 7 | Cement block masonry work in CM 1:6 using good quality, approved cement blocks including charges for conveying, scaffolding charges etc. as per departmental instructions for super structure walls up to floor five level, excluding cost of cement |
| 8 | Cement plastering with CM 1:4,12 mm thick one coat floated hard and trowelled smooth at all levels,excluding cost of cement. |
| 9 | Waterproofing of Bathroom/ toilet floor:i) Surface preparation by cleaning the surface using wire brush in order to remove all deleterious matters and cleaning with water jet spray (if required) including removing old worn out tar felt, deleterious materials etc. ii) All pipe penetration shall be sealed with polymer modified mortar (PMM).iii) Saturate the surface with clean water before application of waterproof coating system. Once water get dried off apply one coat of High Performance & Ultra flexible polymer modified elastomeric waterproofing membrane system of Fosroc-Brushbond ultrafex or equivalent system over the concrete followed a reinforcement fibre mesh over the layer of membrane. iv) Apply two coats of High Performance & Ultra flexible polymer modified elastomeric waterproofing membrane system over the above mentioned initial layer after sufficient curing for each layer (Total consumption requirement for all 3 coats as per manufacturer\"s spec) |
| 10 | Providing and laying with approved brand rectified Glazed Ceramic floor tiles of size 600x600 mm or more (thickness to be specified by the manufacturer), of 1st quality conforming to IS : 15622, of approved make, in suitable colours laid on 20 mm thick cement mortar 1:4 (1 Cement: 4 Coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqm with adequate joint spacing of 3mm followed by grouting the joints of flooring tiles having joints of 3 mm width, using epoxy grout mix of 0.70 kg of organic coated filler of desired shade (0.10 kg of hardener and 0.20 kg of resin per kg), including filling / grouting and finishing complete as per direction of Engineer-in-charge, excluding the cost of cement. |
| 11 | Providing and fixing first quality ceramic glazed wall tiles conforming to IS :15622 (thickness to be specified by the manufacturer ) of approved make in all colours, shades of any size as approved by Engineer-in-Charge for dadoing to walls cement based high polymer modified quick-set tile adhesive (Water based) conforming to IS: 15477, in average 3mm thickness. i followed by grouting the joints of flooring tiles having joints of 3 mm width, using epoxy grout mix of 0.70 kg of organic coated filler of desired shade (0.10 kg of hardener and 0.20 kg of resin per kg), including filling / grouting and finishing complete as per direction of Engineer-in-charge |
| 12 | Providing and laying glazed vitrified floor tiles with approved brand and of size 600x600mm or nearest available size (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS: 15622 and fixing floor tiles with cement based high polymer modified quick-set tile adhesive (Water based) conforming to IS: 15477 in average 3 mm thickness and Grouting the joints of flooring tiles having joints of 3 mm width, using epoxy grout mix of 0.70 kg of organic coated filler of desired shade (0.10 kg of hardener and 0.20 kg of resin per kg), including filling / grouting and finishing complete as per direction of Engineer-in-charge |
| 13 | Providing and fixing vitrified floor tiles with water absorption less than 0.08% and conforming to IS :15622 (thickness to be specified by the manufacturer ) of approved make in all colours, shades of any size as approved by Engineer-in-Charge for skirting (height 10cm) to walls over 12 mm thick bed of cement Mortar 1:3 (1cement: 3 coarse sand) and jointing with grey cement slurry @ 3.3kg per sqmwith adequate joint spacing of 3mm followed by grouting the joints of flooring tiles having joints of 3 mm width, using epoxy grout mix of 0.70 kg of organic coated filler of desired shade (0.10 kg of hardener and 0.20 kg of resin per kg),including filling / grouting and finishing complete as per direction of Engineer-in-charge, excluding cost of cement |
| 14 | Supplying and fixing Factory made flush door of approved make and of1.20 m x 2.10 m size in single leaf, 35 mm thick with both side Veneered door shutter with matching Veneer wrapped engineered wood Jamb 100mmx36mm with front side 65 mm Architraves with back side tackers 26mm all with specialized Lacquer Polish , with Extruded Sauerland Core filling from Germany including 4 side PVC edge banding, Lock Hole Boring (for mortice lock)/ Hinge Rebate Cutting (3 Nos.) including charges for loading/ unloading, transportation, installation by authorised crew of manufacturer and with following fittings of same manufacturer: Mortise Lock with Lever handles with One Side Key Other side Thumb turn -SSfinish - SUS 202 of Jacson or eqvt approved make - 1 No. Hinges 4\" x 3\" x 3mm S S finish -3 Nos.Magnetic door stopper SS Finish - 1 No. Additional fittings if any required shall be included in the quoted rate. The installation and the setting instructions should be strictly followed as per the manufacturer\"s recommendations. |
| 15 | Providing and fixing PVC door of syntex or equivalant make with shutter frame made of extruded plastic section having dimension of 60 x 24 mm or nearest, paneling with single panel hollow plastic section of 20 mm thick with average wall thickness of 1 mm and outer frame of door made of extruded plastic section of 48 x 40 mm or nearest including providing and fixing all required fittings such as stainless steel butt hinges, PVC tower bolts, PVC handles etc.complete as per manufacturers specifications |
| 16 | Supplying and fixing at all levels one piece European Water Closet with slim soft closing seat cover and twin flush fittings Cattler of CERA or equivalent approved quality /brand of size 655 x 355x 730 mm with P/S trap with all required fittings 1 No. 15mm superior PVC connection heavy type ,15mm CP regulating anglecock with wall flange, cutting and making good the walls and floors including giving connection to sewer pipe with all necessary specials,etc. complete as per direction at site |
| 17 | Supplying conveying and fitting 450 x 425 x 330 Wash Basin Cuddle Neo of CERA/ equivalent with a pair of special alloy bolts for fixing the basin on walls with 1No. 15 mm heavy type CP quarter turnpillar cock with aerator of approved make 1 No.heavy type 15 mmPVC connection with CP learning nut 1 No.and 1 No.15 mm CP regulating valve of superior make ,1 No. 15mmCP waste coupling, 32mm PVC waste pipe etc. including cutting and making goodthe walls etc. complete. |
| 18 | Supplying and fixing Health faucet ABS body with 1 meter SS braided connection pipe and hook, F8030105AB of CERA/ equivalent |
| 19 | Supply and fixing of SS304 towel rail 24\" length F5015103CH from meridian series of CERA/ equivalent |
| 20 | Supply and fixing of SS304 soap dish F5015106CH from meridian series of CERA/ equivalent |
| 21 | Supply and fixing of SS304 paper holder with flap guard F5015110CH from meridian series of CERA/ equivalent |
| 22 | Supplying and fixing PVC floor trap (single or multy type) of approved brand 110 mm size with required provision of outlets and inlets as per manufacturers specifications, cutting and making good the walls and floors, etc. complete. |
| 23 | Supplying and fixing 125 mm (5 inch) Stainless steel floor gratings (two piece) to PVC trap as per instructions at site. |
| 24 | Supplying and fixing PVC pipes conforming to IS 4985 class III, 6 kg/sq.cm pressure for lines with all required specials such as plain bends, single junctions, elbows, crosses, unions, shoes, door bends, double junctions, vent cowls, etc. with or without door including cutting masonry or concrete floors, sunshades, etc and making the holes good after finishing the work. wherever necessary and jointing pipes with approved quality resin cement and fixing pipes with MS fixing clamps screwed on to wooden plugs embedded in masonry wherever required and painting the clamps with two coats of enamel paint over one coat primer. This includes testing of joints complete at all levels. for waste water lines:110mm or nearest outer diameter. |
| 25 | Supplying and fixing PVC pipes conforming to IS 4985 class III, 6 kg/sq.cm pressure for lines with all required specials such as plain bends, single junctions, elbows, crosses, unions, shoes, door bends, double junctions, vent cowls, etc. with or without door including cutting masonry or concrete floors, sunshades, etc and making the holes good after finishing the work. wherever necessary and jointing pipes with approved quality resin cement and fixing pipes with MS fixing clamps screwed on to wooden plugs embedded in masonry wherever required and painting the clamps with two coats of enamel paint over one coat primer. This includes testing of joints complete at all levels. for waste water lines 75mm or nearest outer dia. |
| 26 | Supplying, laying and jointing with solvent cement, Rigid PVC pipes conforming to IS 4985 Class V (10 Kg/cm2 pressure rating) for water lines with all required concealed (brass embeded) PVC specials, such as Tees, bends, elbow, union, reducer etc. with clamps if any including necessary cutting and making good the walls, earth work if required etc.complete for 25 mm OD Pipe. |
| 27 | Providing and fixing A grade wallpaper made of vinyl with paperback,thickness 0.4mm in finishes such as matt,semi-glass,or high glass.The wallpaper will be durable,washable,scrubbable and resistance to scratches. |
| 28 | Providing labour assistance for emergency works which are not covered in the Schedule of work-Man Mazdoor |
