|
| 1 | Supply Item |
| 2 | Supply of M.S. Holding Clamps(As per Specification of RESPO & UPCL) |
| 3 | Supply of Bracing Clamp SP-72(As per Specification of RESPO & UPCL) |
| 4 | Supply of Nut & Bolts(As per Specification of RESPO & UPCL) |
| 5 | Supply of E- CLAMP(As per Specification of RESPO & UPCL) |
| 6 | Supply of X ARM HOLDING CLAMP(As per Specification of RESPO & UPCL) |
| 7 | Supply of HT Stay Insulator(As per Specification of RESPO & UPCL) |
| 8 | Supply of Stay Clamp With N&B(As per Specification of RESPO & UPCL) |
| 9 | Supply of Earth Wire Clamp(As per Specification of RESPO & UPCL) |
| 10 | Supply of 33 KV Mid Span Jointing Kit(As per GTP & Specification of UPCL) |
| 11 | Supply of 33 KV Tension clamp with Bail & IPC(As per GTP & Specification of UPCL) |
| 12 | Supply of 33 KV Cable ties for Pin insulator(As per GTP & Specification of UPCL) |
| 13 | Supply of 33 KV IPC for covered to covered conductor(As per GTP & Specification of UPCL) |
| 14 | Supply of 33 KV IPC for covered to Bare conductor(As per GTP & Specification of UPCL) |
| 15 | Supply of IPC with aluminium bail for earthing(As per GTP & Specification of UPCL) |
| 16 | Supply of PANTHER TO PANTHER CTYPE WEDGE CONNEC -D(As per GTP & Specification of UPCL) |
| 17 | Supply of 33KV AAAC COVERED COND. AL-59,241 SQ.MM.(As per GTP & Specification of UPCL) |
| 18 | Supply of BARBED WIRE |
| 19 | Supply of HT TAPE |
| 20 | AAAC Work |
| 21 | Fabrication of M.S. Channel Angle iron after cutting in requiredsizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESSPO sehedule and local approved drawing. |
| 22 | Excavation of earth for Stay pit of size 0.6x0.6x1.2mtrin all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work |
| 23 | Fixing , tightening and nozzaling of 33 KV Stay with pole and stay rod on required tension as per drawing / RESSPO manual. |
| 24 | Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement :4 graded stone 20mm nominal size: 8 coarse sand ) block including cost of Cement,sand andstone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO Manual. |
| 25 | Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work |
| 26 | Erection of STP SP-55 Singlesupport polein proper level and alignment alongwith fixing of all accessories, like top channel & clampsas per RESSPO construction Manual. |
| 27 | Erection of STP SP-72 Double support polein proper level and alignment alongwith fixing of all accessories, like top channel & clampsas per RESSPO construction Manual. |
| 28 | Erection of STP SP-72 Four support polein proper level and alignment alongwith fixing of all accessories, like top channel & clampsas per RESSPO construction Manual. |
| 29 | Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement :4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand andstone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO construction Manual. |
| 30 | Muffing of poles size 0.45 cm x 0.60 cm radious with cc 1:3:6(1 cement :3 coarse sand :6 graded stone 10mm nominal size) blocksize 45cm height from ground level including cost of cement, stone and sand etc. |
| 31 | Dismantling of STP SP 55 Single Pole including disc fitting, Insulator, clamps, Nut & Bolts and consumer connections and Street light connections etc. including rolling of conductor and cartage back from site to JE store |
| 32 | Dismantling of STP SP 55 Double Pole including disc fitting, Insulator, clamps, Nut & Bolts and consumer connections and Street light connections etc. including rolling of conductor and cartage back from site to JE store |
| 33 | Dismantling of STP SP 55 Four Pole including disc fitting, Insulator, clamps, Nut & Bolts and consumer connections and Street light connections etc. including rolling of conductor and cartage back from site to JE store |
| 34 | Painting of SP-55 poles with angle and channel and all steel part by one coat of Rod Oxide Primer and two coats of aluminium Paint and two strip of fluorescent altemate Red and White paint 30 Cm wide upto 1.5 Mtrs. From ground level. |
| 35 | Painting of SP-72 poles with angle and channel and all steel part by one coat of Rod Oxide Primer and two coats of aluminium Paint and two strip of fluorescent altemate Red and White paint 30 Cm wide upto 1.5 Mtrs. From ground level. |
| 36 | Providing and fixing of Danger Board and number plate complete by providing clamps of M.S. Flat 50x6 mm and Nuts & Bolts, danger Boards of M.S. Sheet 2 mm Thick 11\"\"x7\"\" size (Including cost of all material) |
| 37 | Making of section pole complete in all respect. |
| 38 | Cartage of ST pole SP-55 Poles from store centre to construction site with loading, unloading at both points. (loading, unloading pluse carriage per pole) and proper stacking.0-20 KM |
| 39 | Cartage of ST pole SP-72 Poles from store centre to construction site with loading, unloading at both points. (loading, unloading pluse carriage per pole) and proper stacking.0-20 KM |
| 40 | Cartage of other material (other than poles) by vehicle fro Store Center to nearest construction site Store including loading and unloading at both ends,0-20 KM |
| 41 | Headload cartage of SP-55 POLE from road to site (Rates are per pole / KM(0-1KM) |
| 42 | Headload cartage of SP-72 POLE from road to site (Rates are per pole / KM(0-1KM) |
| 43 | Headload cartage of Small material. Rates are per Km/Quintal including loadingand Unloading.(0-1 KM) |
| 44 | DISMANTLING OF 33 KV LINE(PANTHER/DOG) including disc fitting, Insulator, clamps, Nut & Bolts and consumer connections and Street light connections etc. including rolling of conductor and cartage back from site to JE store |
| 45 | BACK CARTAGE OF PETTY MATERIAL,0-20 KM |
| 46 | FIXING OF 33 KV TENSION CLAMP WITH IPC |
| 47 | FIXING OF 33 KV IPC FOR CC TO CC COND |
| 48 | FIXING OF 33 KV IPC FOR CC TO BARE COND. |
| 49 | FIXING OF 33 KV MID SPAN JOINTING KIT |
| 50 | FIXING OF IPC WITH AL. BAIL FOR EARTHING |
| 51 | BACK HEAD LOAD CART. OF PETTY MAT. 0-1KM |
| 52 | FIXING OF 33KV CABLE TIES |
| 53 | LAYING SPREADING,STRINGING AAAC CONDUCT. |
| 54 | Route cleareance by cutting of tree branches / proning, loping and chopping of trees for33 KV line. |
