|
| 1 | Earth work in surface excavation exceeding 30 cm in depth but exceeding 1.5 m in width as well as 10 sqm on plan including getting out and disposal of excavated earth upto 50 m and lift upto 1.5 m, as directed by Engineer-in- Charge: |
| 2 | Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift upto 1.5 m. |
| 3 | Supplying and Filling in Plinth with Sand Under Floors including watering ramming consolidating and dressing complete |
| 4 | Providing and Laying cement Concrete 1:4:8(1cement:4 coarse sand(Zone-III):8graded stone aggregate 40 mm nominal size derived from natural resources) |
| 5 | Centering and Shuttering including strutting propping etc and removal of formwork for Foundation, Footings and Bases of columns |
| 6 | Lintels beams bressumers girders and cantilevers with water prrof 12 mm thick ply |
| 7 | Providing and Laying Damp Proof Course 50 mm thick with cement concrete1:2:4(1cement:2 coarse sand(Zone-III): 4graded stone aggregate 20 mm nominal size derived from natural resources) |
| 8 | Providing & doing Brick work with common burnt clay bricks FPSnon modularin below foundation of class designate 75 in foundation and plinth in CM1:4 |
| 9 | Structural steel work fixed with or without connecting plate including cutting hoisting fixing in position,and applying a priming coat of approved steel primer all complete |
| 10 | Providing & Fixing MSSheet Door Frame of 40X40X6 mm agnle iron3 mm gusset plates at the Junctions,and corners 25 mm dia pulley including all necessary fittings and primer coat of approved steel primer using MS agnles40X40X6 for diagonal braces |
| 11 | 12mm cement plaster in single coat on fair side of single or half brick wall for exterior plastering up to floor two level including internal rounded angles chamfers, and/or roundedangles not exceeding 80mm in girth and finished even and smooth no extra for mixing any additive. 1:6 (1 cement: 6 coarse sand) |
| 12 | Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade : New work (two or more coats) over and including water thinnable priming coat with cement primer. |
| 13 | Painting withsynthetic enamel paint of approvedbrandand manufactureto give an even shade:Two or more coats on new work. |
| 14 | Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. |
| 15 | Steel Reinforcement in RCC Works including straightening, cutting, bending and Fixing in Position, and Binding all complete above plinth level TMT bars of FE500 or more grade |
| 16 | Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including, cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete Hot finished seamless type tubes |
| 17 | Demolishing R.C.C. work manually/ by mechanical means including stacking of steel bars and disposal of unserviceable material within 50 metres lead as per direction of Engineer - in- charge. |
| 18 | Centering and Shuttering for Suspended floors roofs landingsbalconies and access platforms with waterprrof ply 12mm thick |
| 19 | Reinforced cement concrete in beams , suspended floors,roofs having slope upto 15degree landings, balconies, shelves, chajja, lintels, bads, plain window sills, staircases, spiral staircases, above pinth level upto floor five, excluding cost of centering shuttering, finishing and reinforcement upto floor five1:1.5:3 derived from natural resources |
| 20 | Providing and fixing thermal Insulation of ceiling and Walls with Fibre Glass Wool Confirming to IS8183 density 24kg/m3,50mm thick wrapped in 200G Virgin Polythene Bags fixed to ceiling and walls with metallic cleats 50X50X3mm @60cm and wire mesh of 12.5mmX24guage wire mesh |
| 21 | Providing and Fixing Plain Multipurpose cement Fibre Board(High Pressure Steam Cured) with suitablescrews for cement particle board in cmeent and walls etc 6mm thick cement fibre board Type B Category _III as per IS 14862:2000 |
| 22 | Fabrication Chargesof MS Railing using Old MS Steel Sectionsincluding, cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete Hot finished seamless type tubes |
| 23 | Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams persqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyestertop coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratchesduring transportation and should be supplied in single length upto 12 metre or as desired by Engineer-incharge.The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters andtrusses and including cutting to size and shape wherever required. |
| 24 | Providing and fixing GI chain link fabric fencing of required width in mesh size 50mmX50mm including strengthening with 2 mm dia wire or nuts bolts and washers as required complete as per directions of engineer Incharge, Made up of GI wire of 4mm |
| 25 | Excavating suplying, stacking and filling of local earth including royalty by mechanical transport upto lead of 5km also including ramming and watering of earth in layers not exceeding 20 cm in foundation trenches plinth sides of foundation etc complete |
| 26 | Carriage of material by mechanical transport including loading unloading and stacking earth lead 8km |
