Tender For Repair Work Of 07 Anganwadi Centers In Identified Villages (Srinagar-1, Bhagwanpur-1, Mojri-1, Dheso Ramnagar-2, Baraipar (Vasuli) Renghiya, Kamta-3) In Development Block Nichlaul. - 1 Dismantling Old Plaster Or Skirting Raking Out Joints And, Maharajganj-Uttar Pradesh

Tender For Repair work of 07 Anganwadi centers in identified villages (Srinagar-1, Bhagwanpur-1, Mojri-1, Dheso Ramnagar-2, Baraipar (Vasuli) Renghiya, Kamta-3) in development block Nichlaul. - 1 Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead. As per DSR 15.56 (Qty 104.21x7) = 729.46 Sqm 2 Removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc.completeas per (DSR-13.88)(Qty 113.01x7) = 791.07 Sqm 3 Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineer-incharge. As per DSR 2.6.1(Qty 3.00x7) = 21.00 Cum 4 Cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20 mm nominal size) upto plinth level with :As per DSR 7.1(Qty 0.44x5 + 0.46x2) = 3.12 Cum 5 Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand) As per DSR 6.1.1(Qty 0.56x5 + 0.58x2) = 3.96 Cum 6 Supply and fixing of Murga jali½24 gauge for grapping mortar. As per material item SI No. 13(iii) (Qty 56.65x7) = 396.55 Sqm 7 Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) As per (DSR-5.1.3) (Qty 2.83x5 + 2.75x2) = 19.65 Cum 8 12 mm thick plaster with cement mortar inproportion of 1:4 cement and fine sand over brick work minium thickness not be less than 10 mm including supply of all materials, labour and T&P etc. required for proper, comletion of work. As per (DSR-13.1.1)(Qty 104.21x7) = 729.46 Sqm 9 Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacture) with Water absorption ´s less than 0.08% and conforming to is 156622 of approved make in all colours and shade laid on 20mm thick cement mortor 1:4 including grouting the joints with white cement and matching pigment etc .complete. As per (DSR-11.41.1)(Qty 51.12x5) = 255.60 Cum 10 Wall painting with acrylic emulsion paint, having VOC (Volatile Organic Compound) content less than 50 grams/ litre, of approved brand and manufacture, including applying additional coats wherever required, to achieve even shade and colour. two coatas per (DSR-13.82.2)(Qty 260.52x7) = 1823.64 Sqm 11 Painting two coat over on primming coat enamel paint over door, windows and chaukhat, grill etc. complete as per (DSR-13.62.1) (Qty 19.53x5 + 23.54x2 ) = 144.73 Sqm 12 P/F ISI marcked flush door shutter 35 mmthick complete as per (DSR-9.21.2)(Qty 1x7) = 7 Nos. 13 Providing and fixing hand rail of approved size by welding etc. to steel ladder railing, balcony railing, staircase railing and similar works, including applying priming coat of approved steel primer M.S. tube as per (DSR-10.26.1) (Qty 1.77x7) = 12.39 Kg 14 Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.40 mm thick with 20 mm nominal size stone aggregate. As per (DSR-11.3.1)(Qty 58.33x2) = 116.66 Sqm 15 Providing and fixing Electrification work. 16 Wiring point for Light with 1.0 sq.mm.FR PVC insulated multistrand copper conductor cable in PVC Conduit on Surface, complete with 1.5 sq.mm.FRmultistrand copper conductor cable as earth continuity wire, modular type switch & ceiling rose/ angle/ batten holder on 3mm thick phinolic laminatedBakelite sheet etc.with Inverter wiring in wiring point for light complete in all respect. SI.No.121(C)+187(A)+189(A) 17 Wiring point for fan As per item No.1 i/c Inverter wiring SI.No.123 (C)+187(A)+189(A) 18 Wiring point for plug point As per item No. 1 i/c Inverter wiringSI.No.124(C)+187(C)+189(A) 19 Supply and fixing of LED tube light with baten suitable for up to 1x22 watts LED tube light fittings i/c tube on surface complete in all respect.SI No.1413 CAT-AA 20 S/F of Electronic fan Regulator (Modular) 120-180 v As SI.No.1203C 21 Erection and Testing of Ceiling Fan i/c all.SI.No.1116 22 S/F of Cut Out 15A 240V As per SI.No. 1111 23 S/F 6 Amp to 32 AmpMCB as per S.I No.1002 24 Providing and fixing Water supply & Sanitary work. 25 Providing and fixing water closet squatting pan (Indian type W.C. pan ) with 100 mm sand cast Iron P or S trap, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required: White Vitreous china Orissa pattern W.C. pan of size 580x440 mm with integral type foot rests. As per DSR 17.1.1 26 P/F wash basin with C.I. brackets ,15 mm C.P. brass piller tap ,32 mm C.P. brass waste of standard pattern inclding china pedestal complete with all respect. As per DSR 17.25.2 27 Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes,having thermal stability for hot & cold water supply including all CPVC plain & brass threaded fittings This includes with 20mm dia nominal bore (18.8.2)joints complete as per direction of Engineer in Charge. one step CPVC solvent cement ,trenching ,refilling & testing of jointing of pipes & fittings. As per DSR 18.8.2 28 P/F unplasticised PVC pipe with brass unions15mm dia nominal bore. As per DSR 18.21.2.2 29 P/F unplasticised gun metal gate valve with C.I. wheel of approved qulity. As per DSR 18.17.1 30 P/F 15 mm dia C.P. brass stop cock(concealed) of standard design and of approved make conforming IS:8931 As per DSR 18.52.1 31 P/FC.P. brass long body bib cockbrass bib cock of approved quality. As per DSR 18.51.1 32 P/FC.P. brass angle valve for basinof approved quality. As per DSR 18.53.1 33 PVC Pipe 75 mm dia 34 PVC Pipe 110 mm dia Integrated 35 P/F PVC waste Pipe 32 mm dia Flexible. As per DSR 17.28.2.1 36 Providing and placing on terrace polythene storage tank ISI:12701 material with cover and suitable locking arrangement necessaryholes for inlet,outlet and overflow pipe but without fittings and the base support of tank. As per DSR 18.48 37 P/F Factory made single extruded WPC solid Door frame of size 45x85mm complete as per (DSR-26.86.2) (Qty 14.00x2) = 28.00 Rmt 38 P/F ISI marcked flush door shutter 35 mmthick complete as per (DSR-9.21.2)(Qty 13.20x2) = 26.40 Sqm 39 GST @ 18%

INR 944 /-

INR 14 Lakhs /-

FileName	File Description	File Size
Click here to download tender document	Tender Documents	0 KB
Click here to download tender document	Tender Documents	0 KB
Click here to download tender document	Tender Documents	0 KB
Click here to download tender document	Tender Documents	0 KB