Tender For Construction Of Community Hall Building At Aripuram Village In K.Athangudi Panchayat.; 1 Construction of Community Hall Building at Aripuram Village in K.Athangudi Panchayat 2 Earth work excavation and depositing on banks with initial lead and lift in gravelly soil stiff clay, hard stiff clay, murram, boulders mixed with gravel as per SS 20-B for foundation. 3 Filling M.Sand including cost and conveyance loading unloading from approved quarry to work site and labour charges for filling, ramming, etc. complete 4 Collection and supply of gritty gravel from appd quarry including cost and conveyance of all materials to site including all labour charges for fillingetc.complete, 5 Cement concrete 1:4:8 mix using 40mm ISS HBG metal including all cost and conveyance, labour charges etc. 6 Brick work in CM 1:5 mix using country Bricks including cost and conveyance labour charges etc. 7 Supply and errecting sheet centering of size 90 cm x 60cm 10 G sheet laid over silver oak joist and supported by casurina post of size 10 cm x 13 cm dia spaced at 75 cm center to center etc. complete 8 Upto Basement 9 Column 10 Lintel ,Sunshade,Roof 11 Supply and fabrication of steel for RCC works including cost and conveyance charges etc 12 RCC 1 :1.5 : 3 mix using 20mm ISS HBG metal including cost and conveyance of all materials but excluding centering charges including labour charges for mixing laying concrete etc., complete 13 Cement concrete 1:2:4 mix using 20mm ISS HBG metal including all cost and conveyance, labour charges etc. 14 Brick jelly Lime concrete by using 20 mm brick jelly with lime in the ratio of 32 : 12.5 including cost conveyance of all materials and labour charges for mixing laying compacting well beaten with wooden batens etc complete 15 Finishing the Top of Roof with one course of Pressed Tiles of size 23 cm x 23 cm x 2 cm laid in cement mortor 1 : 3 and pointing with the same mortor mixed with water proof compound including cost and conveyance off all materials and labour charges etc complete 16 Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing.The Surface shall then be allowed to dry for atleast 48 hours.It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface.Any unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. [ The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete].The Putty shoule be got approved by the Executive Engineer before use on work. 17 Special ceiling Plastering with CM 1:3 10mm thick including cost and conveyance charges etc., 18 Plastering in CM 1:5, 12mm thick including cost and conveyance charges etc., 19 Paving the Floor with scratch proof ceramic tiles of size 305x305x6mm including cost and conveyance of all materials to site and all labour charges etc complete 20 Dadooring walls with glazed tiles of size 0.15 x 0.15 set with CM 1:3, 10 mm thick etc., complete 21 Distembering two coats oil bound distemberover priming coatinculding cost and conveyance of all materials to site and all loboure charges etccomplete ( Innerwall ) 22 Exterior Emulsion painting two coats with best approved quality and colourpaint over one coat of Base coat including cost and convyance of all materials to work site and labour charges etc., complete. 23 Painting two coats with ready mixed paint including cost and conveyance charges etc. 24 Providing Electrical Arrangements 25 Wiring with 2x2.5 sq.mm PVC sheathed SC alu.cable of 650 V Grade partly on TW fillets and partly in PVC rigid pipe concealed for vertical drops with TW and PVC accessories with T.W switch box to house control switch and regulator with 3mm thick Hylem sheet cover with painting on T.W fillets portion, and making good of the concealed portion with suitable colour for fan point.(S.D.No. 32) 26 Wiring with 2x 1.5sq.mm(22/0.3)PVC Insulated sc.cu. Conductor of 1100VPVC rigid pipe on wall7celing for open PVC plug point 27 Supply and Fixing of 25 Amps DP Switch of500V with Metal Clad with Fuse and Neutral SD 144 28 Supply and fixingOF T W BOARD OF SIZE 400X300X5MM TK BOARD TO HOUSE THE METER BOARD INCLUDING FUSING WITH Proper earthing for meter board 29 Supply and fixing of 4 40 W Twin Mirror optic suspension type fitting (Philips / Crompton / Wipro) complete with louvers cover complete with copper choke and condensor with conduit pipe suspension, with PVC unsheathed Copper leads from the terminals to the fittings with flu. tubes 30 Supply and run of 2X1.5sqmm(22/.30)PVC insulated SCunsheathedCu.Conducted of 1100v GRADE IN 25 MM DIA gi pipe(class B)with necessary angle ir on supports for mains. 31 Supply and run of 2 of 6 sqmm(84/.30)PVC insulated SCunsheathedCu.Conducted of 1100V7/20GI bearer wire for SERVICE CONNECTION MAINS 32 Supply and fixing of 1200 mm (48) AC ceiling fan complete with stepped electronic 300W regulator with 300mm down rod on the existing clamp. 33 Providing Of CFL Light 34 Providing Of Exaust fan 35 PROVIDING BOREWELL 36 Drilling of borewells in anywhere in Tamlnadu including transportations from one place to another place within the circle juristiction Alluvial soil of sedimentary starta of calyx and sand or sand stone stale, febbles, boulders etc;by first taking a Drilling 140/150mm pilot bore upto 60m depth ending below ground level 37 0 M to 60m 38 60 M to 90m 39 Reaming from140/150mmpilot boreto 300mm dia bore0upto 60m depth ending from G.L. 40 0 M to 60m 41 60 M to 90m 42 Supply of 150 MM dia (O.D) PVC ribbed borewell casing pipe 43 Plain Pipe 44 Slotted 45 Labour charges for inserting the casing pipes assemble with or without slotting in the drilled hole supplying and packing the annular space with pebbles of size and quantity 46 Charges for development of bore well air compressor of 600 CFM capacity including transportaion charge fuel etc., and ascertaining the yield of the bore well as directed by department officers developed abore well 8hrs minimum 47 Providing Motor Connection 48 Supply &delivery ofvertical typesubmersible 3 HP pumpset of discharge 50 lpm against a total head of 100 m suitable for borewellconformingto IS 8034/2002 and as amendedfromtime to time with ISI markwith all asccessoriesand suitable panel Boards 49 Dust proof powder coated MV panel board of 18 SWG MS sheet and MS angle iron frame work with hinged front doors and fixed sides with locking arrangements ,provision for cable entry and twin earthing complete as per IE Rules (3 Phase DOL panel board 50 Supply and delivery of 4sqrm PVC copper flat submersible cable 51 Supply and delivery of the following size of GI and PVC specials as per IS specification 52 50mmUPVC -Column Pipe 53 50mm GI bend 54 50mm M.S.Clamp set 55 50mm GM Non return valve 56 50mm GM Gate valve 57 Labour charges for erection of 3 HP submersible pumpset in Borewell including fixing and jointing of submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the required depth valves erection clamps pressure guage upto the exterior wall of the pumproom and erection of the Board consisting of TPICN switch starter volt meter ammeter, 3 pilot (indicating) capacitor, single phasing preventor water level guard and laying and jointing the cable and twin earthing as per IE rules etc. complete and testing the pumpset on trail run for 3 days including signing the completion reports as required by EB authorities. (P.No:243)S.I.N0. 17 58 Providing Plumbing 59 Supplying and fixing in position best approved quality (Oriya type)white indian type water closet530 mm x 440 mm white glazed earthern ware of approved quality and brand with p or s trap conforming to BIS with sand cushion and forming flooring alround the closet using 40 mm broken brick jelly in lime concrete 1:2:5 (one lime, two sand and five brick jelly) 100 mm thick and finishing the top to the required slope and including giving necessary connection to CI soil pipes (including the cost of 100mm dia CI pipe for a length of 600mm) by dismantling brick masonry wall / reinforced cement concrete roof / floor slab and making good the dismantled portion to the original condition with leakages etc., complete complying with standard specifications and as directed by the departmental officer. 60 Supplying and fixing of Indus floor mounted white colour European water closet Parryware or equivalent, with seat cover and dual flush (3 & 6 lit) cistern having P trap withseat cover, supplyingnon corrosive hinges, CP bolts, nuts, washers, providing and fixing dash anchor fastners with bolts / L -brackets with anticorrosive paint cutting grooves in masonry or concrete surfaces, groutingwith cement concrete 1:2:4 mix, using 20mm size stone jelly,restoring the damaged portion to their original condition using required materials,fixing the water closet to perfect level,alignment,testingetc.complete. 61 Providing and keeping in stores, shifting to the place of installation, fixing,testing and commissioning ofwhite coloured vitreous china under counterRegular rectangular wash basin with brackets/ G.I. rag bolts and nuts painted,32mm dia brass C.P. waste coupling, (heavy) 32mm diabrassC.P.bottletrap,15mmdiabrassC.P.Anglestopcockwith flange, 15mm dia brass C.P. coldwater connecting pipe, etc., The work shall include,required extension nipples, cutting / chasing and making good the walls and floors- toilets. Wash Basin 62 Supplying and fixing approved best quality brass CP towel rail 600mm long and 20mm dia with brackets of same materials including cost of teak wood plugs and CP screws, etc.,complete complying with standard specifications. (The tower rail should be got approved by Executive Engineer before use on works). 63 Supplying and fixing in position Indian make bevelled edge mirror of approved quality and brand PVC / Fibre Glass framed 600 x 450 x 5.5mm thick mirror, shelf type with hard board backing of approved colour fixed with brass screws, rawl plug, etc., complete complying with standard specification. (The mirror should be got approved by the Executive Engineer before use on woks). 64 Supplying and fixing in positionC.P. Soap tray of size 150 x 100mm including cost of teak wood plug and C.P. screws. etc. complete complying with standard specification.(D) 65 PART- B SOIL AND WASTE PIPES 66 Supplying and fixing in position best quality PVC soil / waste pipes of various dia having 6 kg / sq.cm. pressure BIS mark and providing leak proof joints using PVC adhesives including fixing to the wall with special PVC / MS clamp, teak wood plugs, brass screws, etc., and making connection to all sanitary fittings, dismantling masonry / RCC works wherever found necessary and making the good dismantled portion to the original condition,including testing for any leakages,etc.,complete complying with standard specifications.(The PVC pipes should be got approved by the Executive Engineer before use on works). The rate for earth work excavation will be measured and paid separately in the cases where the pipe lines are proposed to laid below ground level. 67 d) 110mm dia. 6kg class PVC pipes. 68 Supplying and fixing in position cost iron Nahini / Floor trap with Stainless steel grating / PVC nahini / Floor Trap with PVC Grating type of size 100 x 75 / 75 x 50 mm with best quality gratings of approved brand fixed over a bed of brick jelly lime concrete 1;2;5 (One lime two sand and five aggregate ) brick jelly 40mm and finishing with cm 1;3(One cement and three sand) including dismantling masonary wherever found necessary and making good to the original condition and giving connections to the cast iron pipe etc, complete complying with standard specififcation and as directed by the departmental Officers. 69 Supplying and fixing of PVC water storage tank of best approved quality and make of super thick with lid ofcapacity of 2000 litres with accessories including giving necessary connection etc., complete as directed by the departmental officer. (The PVC water storage tank should be got approved by the Engineer before use on work)(TWAD- Pano:173) 70 GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column BB for all works in this package}
