Construction Of Primary Health Center Building At Mirzapur (V) Siddipet District. Sub Work: Providing Of Balance Electrical Items Acs, Network And Cc Road Etc-Earth work excavation for foundations (Manual Means) of buildings, septic tank, sump, compound wall in ordinary soils and depositing on bank with an initial lead of 10m and depth up to 3m including all operational,incidental, labour charges such as shoring, sheeting, planking, strutting etc., and complete for finished item of work excluding dewatering charges etc., as per SS 20 B(APSS 308) Plain Cement Concrete (1:4:8) (cement: fine aggregate: Coarse aggregate) for foundations and under flooring bed using coarse aggregate 40mm size hard , machine crushed granite from approved quarry including cost and conveyance of all materials like cement, sand, coarse aggregate, water etc. to site, including sales & other taxes on all materials and including all charges for machine mixing, laying concrete in foundations and under flooring bed, ramming in 15 cm layers finishing top surface to the required level curing etc., and complete for finished item of work. (APSS No. 402). Filling with carted gravel by manual means in trenches, sides of foundations and basement with initial lead in layers not exceeding 15 cm thick, consolidating each deposited layer by watering and ramming including cost and conveyance of water to work site and all operational, incidental, labour charges, hire charges of T & P etc., and complete for fnished item of work. (APSS NO. 309 & 310) Construction of un-reinforced, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade) Cement component not less than 350Kgs / cum, coarse and fine aggregates conforming to IS:383, maximum in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side form work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, scareed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, admixtures as approved, curing of concrete slabs for 14- days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 MORD. including cost & conveyance of all material, labour, complete as directed by the Engineer in Charge. Providing Plinth protection with a bed of 100mm thick PCC(1:5:10) using screened sand ,40mm size HB Granite metal and on top of PCC, 20mm thick granolithic concrete flooring with CC(1:1:2) prop.using 6mm to 12mm size graded hard granite machine crushed metal laid monolithically already laid, in alternate panels of size not exceeding 1.5 x 1.5 Mts. and providing 5mm thick glass strips between the pannels and finishing the top surface to required smoothness and slopes including grooves, thread lining as directed by the Engineer - in - charge including cost and conveyance of all materials to site and operational & incidental and labour charges like mixing of cement concrete, laying, curing, lift charges etc., and complete including cost of CC bed for finished item of work. (APSS No.701 & 710). Supplying and fabricating, erecting and fixing in steel works like Window Grills, Compound Wall Grills, Iron Doors, Windows including cost of welding rods, power charges of approved design and including cost and conveyance of all materials, labour charges for erecting & fixing all structural steel works erecting in position and fixing etc., complete in position, labour charges for fabrication, all incidental charges, etc., complete for finished item of work as directed by the Engineer-in-Charge Supply and fixing of Window side cubical curtains using powder coated aluminium track of size 25mm X 32 mm with fixtures like runners, hookes & hangers inculding cost and conveyance of superioir quality 100 % polyster cloth for hospitals as directed by the Engineerin-charge inculding cost and conveyance of all materials, stiching of cloth etc complete for finished item of work upto height of 2.10 mtr Supply, transportation and installation of 2.0 / 1.8 TR 3 Star capable of delivering 21600 BTU/hr and above with operating on refrigerant R-32 / R-410 INVERTER Model Cool type split AC unit with high wall mounted Single Split 100% copper indoor and outdoor condencing unit Hermetically sealed compressor suitable for operation on 230V, 50Hz, 1Phase AC supply capable of performing Heat cool dehumidifying air circulating and filtering with cooling and condensing units with 3.0 mts of copper piping, insulation kit and 4 mts of 4 core copper flexible chord (Voltage range 160- 264 volts) and cordless remote control with with warranty of compressor for 5 years iand comprehensive maintenance for 2 years Supply and erecting fully automatic line voltage stabilizer for operation on input voltage 200 to 250V. rated for 5 KVA maximum load and time delay model with Volt meter, selector switch, 6A / 16A flush type, 5 pin socket for out put and with 3 core flexible chord and 3 pin 6/16A plug top suitable for AC for continuous operation including cost and conveyance of all mateials and all labour charges etc., complete. Makes : V-Guard / Real Guard / Uni Stab / ITL. Supply and fixing of ABC Powder MAP 4 Kg Fire extinguisher Mono ammonium phosphate power 90, stored pressure type, IS 15683 : 2006, pressure gauge gross wt. 6.9 kg, empty wt. 2.9 kg, can Ht.440mm, Diameter 140mm, Discharge time less than 13 sec, controllable discharge mechanism, range min. 4 mts applicable on classes A,B, C & electrically started fires, A- rating 3A, B-rating 34B, can construction: Deep drawn Co2 mig welding, wall construction: Forging & Machining, internal coating of can: Epoxy power coating, External coating of Can:Epoxy polyster powder coating, sheet metal thickness:1.60mm, Helium leakage detection tested, ISI & CE approved with 5 years warranty Including transportation, all taxes and all labour charges etc complete. Makes : Safex / Kenex / Bharat / Reliance Supply and Fixing of ISI 25mm outer dia medium grade, with IS:9537 part 3 rigid PVC with all accessories fixing on chromium plated metallic base saddles including all labour charges etc., complete for run of mains.Makes:- Sudhakar / Finolex / Modi / VIP / Precision / Universal / Million Plast / Gold / Polycab / DEC. Supply, Transportation and Run of Cat - 6 UTP cable for LAN in the existing conduit pipe and labour charges etc., complete. Makes : D Link / AMP / Molex / Legrand / Krone. Supply, Transportation and Fixing of Cat 6 RJ-45 information outlets including duel face plate with all accessories and labour charges etc., complete. Makes : D Link / AMP / Molex / Legrand / Krone. Supply, Transportation and Fixing of 24 Port - 10 / 100 / 1000 Gigabit Ethernet switches including all accessories and labour charges etc., complete. Makes : Digisol / TP Link / D link. Supply, Transportation and Fixing of 24 port patch panels including all accessories and labour charges etc., complete. Makes : D Link / AMP / Molex / Legrand / Krone Supply and installation of 6U Wall 600 mm width x 500 mm depth UL certified wall mounting net work rack with sheet steel revited metal frame, top and bottom cover with brush cable entry, confirming to following standards IEC 60529, EN 60529 ( IP 20), IEC 62262 EN 62622 (IK 08) , DIN 41494, EIA 310, IEC 60927 including all accessories like horizontal PDU, metal cable manager, hardware packet and the cantilever shelf etc., complete.Makes : Vallrack (Legrand) / Netrack. Supply of 3 feet length moulded patch cord. Makes : Digisol / TP Link / D link. / Legrand
