|
| 1 | 1. Construction of New Anganwadi Bulding at PeriyapattiH/O Periyapatti |
| 2 | Earth work excavation for foundation in all soils such as redearth ,hard stiff clay soil, stiff black cotton soil, hard redearth,shales, murrams, gravel,hard rock not requiring blasting ete complete.,For Foundation |
| 3 | Cement concrete 1:4:8 mix usin 40 mm HBGSmetal inculding cost and coveyance of all materials to site including labour for mixing ,laying,curing etc complete.,For Foundation |
| 4 | Supplying and filling in foundation and basement with filling gravel in larges of not more than 15 cm thick well rammed watered and compacted including & conveyance and all labour charges etc., |
| 5 | Brick work with cement mortar 1:5 mix using II class bricksfor foundation and basement and superstructure inculding cost and conveyance of all materiales curing etc ,complete. |
| 6 | Basement |
| 7 | Super Structure |
| 8 | Supplying and erection centering for sides and soffits inculding necessary supports and structingfor plain surfaces such as RCC Slab,Lintel,Beam coloum,sunshade etc complete., |
| 9 | Below Ground Level |
| 10 | For Column Post |
| 11 | Rate for Sunshade |
| 12 | Rate for Roof slab , Lintel Beam |
| 13 | Supplying and fabrication,placing in position of mild steel or ribbed Tor steel grils for RCC works inculding cost of steel and binding wire etc. |
| 14 | Reinforced cement concrete 1:11/2:3 mix using 20 mmHBGSmetal inculding cost and coveyance of allmaterials to site including labour for mixing ,laying,curing etc complete., |
| 15 | Below Ground Level |
| 16 | Above Ground Level |
| 17 | Plastering with Cement Morter 1:5 mix 12 mm thick inculding cost and conveyanceof all materials to site and labour charges for curing etc |
| 18 | Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing.The Surface shall then be allowed to dry for atleast 48 hours.It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surfaces etc, complete compl |
| 19 | Supplying and fixing in position ordinary colour glazed Indian type water closet of best quality and approved make with 100mm\" P\" or\"S\" trap with double flapped rigit P.V.C seat level flushing tank with 10 liters PVC low level Flushing tank with all interna |
| 20 | Supplying and fixing in position European type water closet of best quality and approved make with 100mm\" P\" or\"S\" trap with double flapped rigit P.V.C seat level flushing tank with 10 liters PVC low level Flushing tank with all interna |
| 21 | Supplying and Fixing inpositionof best quality make White glazed washbasin of size 550x 400mm- 1 No. |
| 22 | Providing granolythic floor finish in cement concrete 1:2:4 mix using 10-12 mm ISS metal to 25mm thick including cost and conveyance of all materials to site and all labour charges etc., |
| 23 | Flooring with following ceramic tiles of size 305 x 305 x 6 mm laid over 20 mm thick cement mortar 1:3 (One Cement and ThreeSand)base mortar over the existing slab / floor including cutting the tiles to the required size with special cutter wherever necessary, laying in position and pointing with white cement mixed with colouring pigment at the rate of 0.3 Kg. / sq.m. etc., complete complying with standard specification.(The make and brand of the tiles should be got approved by Executive Engineer before use on works) |
| 24 | Dadooing walls with Glazed tiles of any colour and any size laid in CM 1:2, 10mm thick. and pointing with white cement 0.4 Kg per sqm mixed with colouring pigment to siut the colour of the tiles including finishing the joints neatly complying with the standard specifications and as directed by the departmental officers. The Glazed tiles should be got approved from the Departmental officers before execution. |
| 25 | Plastering with CM 1:3,12mm thick. over the cement concrete for floor finish including curing etc., complete complying with standard specifications and as directed by the departmental officers. |
| 26 | Weathering course with best quality broken brick jelly of size 20mm uniform gauge in pure slaked lime (no sand to be listed) over the RCC roof slab in the proposition being brickjelly to lime 32:12:1/2 by volume and laid over into a single layer and consolidated to required finished thickness beating the mixture with wooden beaters keeping the surface constantly welted by sprinkling lime jaggery water including all other labour charges etc., complete |
| 27 | Finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 20mm of approved quality set in Cement Mortar 1:3 (One Cement and Three Crushed stoneM.Sand) 12mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers |
| 28 | Distembering two coats of oil bound distember using one coat of primer coat including cost & conveyance to size and all labour charges etc., complete. |
| 29 | Painting two coats with ready mixed Exterior Emulsion paint of approved qualityand colour over a priming coat, including through scrapping,clean removel of dirt etc complete . |
| 30 | Painting two coats of new iron work with best quality synthetic enamel paint of approved quality and colour with priming coatincluding the cost all materials etc.,complete, in all floors. |
| 31 | Supplying & fixingwith cuddapah slabs 40mm thickand pointed with cement mortar 1:3 |
| 32 | Supplying and fixing PVC Rain water down fall pipes of following dia meter etc., complete.110mm dia PVC Rain water Pipe |
| 33 | Fabricating Supply and fixing and position of MS doors with single leave. The door outer frame will be 40x40x6mm MS angle, the shutter frame will be 35x35x6 mm, MS angle intermediate stiffner will be 35x35x6 mm with cross stiffner 25x 25x5 mm flats covere |
| 34 | Door size 0.90m x 2.40 m |
| 35 | Door size 0.75m x 1.50 m |
| 36 | Door size 1.10m x 2.40 m |
| 37 | Window size1.2X1.60 m |
| 38 | Vetilator |
| 39 | Labour charges for fixing of doors along with Frames in position |
| 40 | Labour charges for fixing of windows along with Frames in position |
| 41 | Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for staircase near wet riser using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick will be provided with tubular supports made of 304L Grade Stainless Steel pipe of 25mm dia of 1.60mm thick welded to the railing. The supports will be grouted into the wall and provided with 93.00mm thick |
| 42 | Wiring with 2 x 2.5 Sq.mm PVC unheated SC allocable of 650V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with PVC accesories in flush with wall,with 3mm thick hylum sheet cover with TW switch box and F.T switch and 5 A FT switch and making good of the concealed portionwith suitable colour forPVC concealed light point / Fan Point SD 25 |
| 43 | Wiring with 2 x 2.5 Sq.mm PVC unheated SC allocable of 650V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150 x 100 x 113mm T.W. switch box in flush with wall, covered with nylon sheet of 3mm thick 5 Amps 3 pin non - interlocking C.S. Plug top with painting of suitable color for open PVC plug point.- SD -41. |
| 44 | Supply and fixing of single box type 4\"-40Wflourescent tube fitting with copper choke and condenser with TWround block on wall or ceiling with flourescent tube with PVC unsheathedcopper leads from terminals to the fitting ofTube Light[SD88 ] |
| 45 | Supply and Fixing of Ceiling fan including cost and conveyance of all materials and labor charges etc complete. SD 110 |
| 46 | Supply and fixing of 16 AmpsDPIC switch of 500V grade with Fuse and Neutralon suitable T.W. board with painting of suitable color with PWD Earthling (SD No.142) |
| 47 | Supply and fixing of TNEB meter Board sutable for 32 A Single Phase service connection with 32 A Fuse Unit (500V) 32 A neutral link and earth link (1\" X 1/8\" copper plateon TW plank ofSize 375 X 300 X 19 mm with suporting TW Reepers of 1\" thick on either side with painting with suitable bolt and nuts for fixing th TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit.[SD no.125] |
| 48 | Supply and run of 2X6.0 sq.mm (22/0.3) polythene insulatedPVC sheathed heavy duty SC.Copper conductor of 1100 V grade in 25mm dia GI pipe(Class B) suitably bent on bothends with necessary Angle iron upright and end supportes for Mains[SD NO. 71] |
| 49 | Supply and run of 2 of 6.0 sq.mm polythene insulated PVC sheathed heavy duty SC.Copper conductorof 1100 V grade on 7/20 GI bearer wire for service connection mains [SD NO.70] |
| 50 | Supply and fixingof W.t Bulk head fitting with guadr suitable lamp with 60 w Bulb (SD 84) |
| 51 | Supply and fixing of 300mm (12\") sweep (light duty) AC exhaust fan complete with necessary wall opening and making good of the wal SD 114 |
| 52 | Supply,Delivery and fixing of HDPE Tank as per IS 12701/1996 including loading , Unloading Etc |
| 53 | GST Amount for providing Service to Government Contract Works for the above Construction & Maintenance Works. { GST Amount is the Total GST Amount for overall quoted amount (Both Construction and Maintenance) above this row in column \"BB\" for all works in this package}(Refer Clause 13.2 & 13.3 of Section 2 of Instruction to Bidders (ITB) of SBD) |
