|
| 1 | Construction of chowkidar /Driver room and parking at Angling hut Bharmour Distt Chamba H.P.( SH:- Providing & Fixing Porch with Collapsible steel shutter & MS railing around parking) |
| 2 | Excavation in foundation, trenches etc. in earth work in all classification of soil such as pick work, jumper work, pick jumper work, blasting work, jumper blasting work, soft and hard blasting and saturated soil, de-watering, including wedging out rocks where blasting work is prohibited, chiseling or any other mixed variety of soil, de-watering and/or removal of slush and incidentals, lift up to any heights, stacking the excavated soil not more than 3 mtrs. (Three meters) clear from the edge of excavation and then retuning the stacked soil in15cm (Fifteen centimeter)layers, whenrequired into plinths, sides of foundation etc; consolidating each deposited layer by ramming, watering and then disposing of all excavated earth as directed by the Engineer-in-charge, |
| 3 | Providing form work with steel plates 3.15 mm .thick welded with angle iron in frame 30 x 30 x5mm. so as to give a fair finish including centring,shuutering, strutting and proppingetc. withwooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in Flat surfaces such as soffits of suspended floors, roofs, landings and the like. including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 4 | Providing form work with steel plates 3.15 mm .thick welded with angle iron in frame 30 x 30 x5mm. so as to give a fair finish including centring,shuutering, strutting and proppingetc. withwooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete workinSides and soffits of beams, beam haunchings , cantilevers, bressumers and lintels not exceeding 1 Mtr. in depth in all heights from floor including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 5 | Providing form work with steel plates 3.15mm .thick welded with angle iron in frame 30 x 30 x 5mm. so as to give a fair finish including centring, shuutering, strutting and propping etc. with wooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in Columns, pillars, posts and struts Square, rectangular or polygonal in plan including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 6 | Providing form work with steel plates 3.15 mm .thick welded with angle iron in frame 30 x 30 x5mm. so as to give a fair finish including centring,shuutering, strutting and proppingetc. withwooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete workinEdges of slabs and breaks in floors and wallsUnder 20 cm. wide. including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 7 | Providing and laying cement concrete1:1.5:3and curing complete excluding cost of form work Suspended floor roofs landing and shelves and their support balconies, beams, girders,etc.including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 8 | Providing and laying cement concrete work 1:1.5:3 (1 cement : 1.5 sand :3 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in Lintels, beams girders bressumers and cantilevers upto floor two level.lintal beams including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 9 | Providing mild steel/Tor steel reinforcement for R.C.C. Work including bending, binding and placing in position complete upto floor two level :including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 10 | 15mm cement plaster in single coat on fair side of brick/ concrete /stone walls for interior plastering upto floor two level including arrises, internal rounded angles, chamfers and/ or rounded angles not exceeding 80mm in girth and finished even and smooth.Cement Mortar 1:5(1 Cement :5 sand) |
| 11 | Providing and laying Duro stone vetrified tiles300x 300mmx 8mm ) in grey/ coloured of required shade in skirting risers of steps and dados on 12mm thick cement mortar 1:3(1cement : 3 sand) laid over and jointed with neat cement slurry finished with flush pointing in white cement mixed with pigment of required shade to match the shade of tiles complete including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 12 | Steel work welded in built up sections,trusses and framed work,including cutting ,hoisting ,fixing in position and applying a priming coat of red lead paint In gratings framed guard bars, ladders ,railling, brackets and similar works including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 13 | Providing and fixing 0.60mm thick prepainted steel sheet in roofing with hot dipped metallic zinc coated sheet with top coat of regular modified polyster (RNP) organic coating of 20 microns over 5 microns primer coating to back coat of polyster of 5 microns over 5 microns primer coating i/c fixing with prepainted iron J or L hooks, bolts and nuts 6mm dia metre with prepainted limpet and rubber washers complete with all accesoriees as required as per the direction of Engineer-in-chargeincluding carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 14 | Providing and fixing ridges or hips 60 cm overall with 0.60mm thick prepainted steel sheets in roofing with hot dipped metalic zinc coated sheets with top coat of regular modified polyster organic coating of 20 microns over 5 microns primer coating + back coat of polyster of 5 microns over 5 microns primer coating i/c fixing with prepainted iron J or L hooks, bolts & nuts 6mm dia & prepainted G.I. limpet and bitumen washers complete with all accessories as required as per the direction of Engineer in Chargesincluding carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 15 | Providing and fixing M.S. BP Sheet 1.66mm to 2mm thick in eaves board/facia/soffits/ceiling including cutting, fixing and welding to steel roof members and applying a coat of red lead primer complete as per the instruction of Engineer-in-charge (Base members of steel work shall be measured & paid separtely)including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 16 | Providing and fixing in position collapsible steel shutters with vertical channels 20 mm X10 mmX2mm and braced with flat iron diagonals 20 mm X5 mm size with top and bottom rails of T.iron 40 mm X40 mm X6 mm with 38 mm dia steel pulley complete with bolts and nuts locking arrangements, stoppers,handles,including applying a priming coat of red lead paintincluding carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 17 | Painting two coats (excluding priming coat)on new steel and other metal surface under coat with ready mixed paint brusing to give an even shade including cleaning the surface all dirt,dust and other foreign matter With readymixed paint other than white including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
| 18 | Finishing wall with water proofing cement paint of approved brand and manufacture and of required shade on undecorated wallsurfaces (two coats)to give an even shade after thoroughly brushing the surface to remove all dirt and remains of loose powdered materials. including carriage of material with in allleads and liftsin all heights as directed by theEngineer-in-charge and other incidentals |
